[PATCH v4 0/7] net: pch_gbe: Fixes & MIPS support

The Intel EG20T Platform Controller Hub is used on the MIPS Boston
development board to provide various peripherals including ethernet.
This series fixes some issues with the pch_gbe driver discovered whilst
in use on the Boston board, and implements support for device tree which
we use to provide the PHY reset GPIO.

Applies atop v4.12-rc4.

Paul Burton (7):
  net: pch_gbe: Mark Minnow PHY reset GPIO active low
  net: pch_gbe: Pull PHY GPIO handling out of Minnow code
  dt-bindings: net: Document Intel pch_gbe binding
  net: pch_gbe: Add device tree support
  net: pch_gbe: Always reset PHY along with MAC
  net: pch_gbe: Allow longer for resets
  net: pch_gbe: Allow build on MIPS platforms

 Documentation/devicetree/bindings/net/pch_gbe.txt  | 25 +++++++
 drivers/net/ethernet/oki-semi/pch_gbe/Kconfig      |  2 +-
 drivers/net/ethernet/oki-semi/pch_gbe/pch_gbe.h    |  4 +-
 .../net/ethernet/oki-semi/pch_gbe/pch_gbe_main.c   | 79 +++++++++++++++++-----
 4 files changed, 91 insertions(+), 19 deletions(-)
 create mode 100644 Documentation/devicetree/bindings/net/pch_gbe.txt

-- 
2.13.0