"Maciej W. Rozycki" wrote:

On Tue, 25 Jun 2002, Carsten Langgaard wrote:

quoted

The next LTP failure line is:
pipe05      1  BROK  :  Unexpected signal 11 received.

For this one I haven't got a fix, because the failure is due to the way
the pipe syscall is implemented for MIPS (so we need a fix in both the
kernel and glibc).

The glibc code look like this
SYSCALL__ (pipe, 1)
        /* Plop in the two descriptors.  */
        sw v0, 0(a0)
        sw v1, 4(a0)

        /* Go out with a clean status.  */
        move v0, zero
        j ra
        .end __pipe

The problem is that the code is called with $a0 = 0. So the 'sw v0,
0(a0)' after the syscall generates a segmentation fault.

 The test is broken and it's what should be fixed, instead -- several
Linux platforms do it this way, e.g. Alpha and IA-64.  A SIGSEGV is a
valid response for an invalid address.  Remember you test pipe(3) and not
pipe(2).

I'm not sure that you mean by pipe(2) and pipe(3), but according to my man
page, pipe should return with EFAULT in this case.

ERRORS
       EMFILE Too  many  file  descriptors are in use by the pro­
              cess.
       ENFILE The system file table is full.
       EFAULT filedes is not valid.

quoted

Why are the pipe syscall implemented this way, where we return the two
descriptors in v0 and v1 ?

 For performance reasons.  Also it's safer to do such actions from the
userland.

quoted

Why doesn't the kernel do these stores (this way we can do an access
check, like i386 does) ?

 I suppose i386 does these stores in the kernel due to historical reasons.
There is also the problem of a permanent lack of registers in i386 -- I
haven't investigated it, but it may simply be unable to afford a second
result register.

--
+  Maciej W. Rozycki, Technical University of Gdansk, Poland   +
+--------------------------------------------------------------+
+        e-mail: macro@ds2.pg.gda.pl, PGP key available        +

--
_    _ ____  ___   Carsten Langgaard   Mailto:carstenl@mips.com
|\  /|||___)(___   MIPS Denmark        Direct: +45 4486 5527
| \/ |||    ____)  Lautrupvang 4B      Switch: +45 4486 5555
  TECHNOLOGIES     2750 Ballerup       Fax...: +45 4486 5556
                   Denmark             http://www.mips.com