[PATCH 05/22] PCI: mediatek: Use SET_PCI_ERROR_RESPONSE() when device not found
From: Naveen Naidu <hidden>
Date: 2021-10-11 17:51:41
Also in:
linux-arm-kernel, linux-mediatek, linux-pci, lkml
Subsystem:
pci native host bridge and endpoint drivers, pci subsystem, pcie driver for mediatek, the rest · Maintainers:
Lorenzo Pieralisi, Krzysztof Wilczyński, Manivannan Sadhasivam, Bjorn Helgaas, Ryder Lee, Linus Torvalds
An MMIO read from a PCI device that doesn't exist or doesn't respond causes a PCI error. There's no real data to return to satisfy the CPU read, so most hardware fabricates ~0 data. Use SET_PCI_ERROR_RESPONSE() to set the error response, when a faulty read occurs. This helps unify PCI error response checking and make error check consistent and easier to find. Compile tested only. Signed-off-by: Naveen Naidu <redacted> --- drivers/pci/controller/pcie-mediatek.c | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/drivers/pci/controller/pcie-mediatek.c b/drivers/pci/controller/pcie-mediatek.c
index 2f3f974977a3..aa744ccd1a2a 100644
--- a/drivers/pci/controller/pcie-mediatek.c
+++ b/drivers/pci/controller/pcie-mediatek.c@@ -369,13 +369,13 @@ static int mtk_pcie_config_read(struct pci_bus *bus, unsigned int devfn, port = mtk_pcie_find_port(bus, devfn); if (!port) { - *val = ~0; + SET_PCI_ERROR_RESPONSE(val); return PCIBIOS_DEVICE_NOT_FOUND; } ret = mtk_pcie_hw_rd_cfg(port, bn, devfn, where, size, val); if (ret) - *val = ~0; + SET_PCI_ERROR_RESPONSE(val); return ret; }
--
2.25.1
_______________________________________________
Linux-kernel-mentees mailing list
Linux-kernel-mentees@lists.linuxfoundation.org
https://lists.linuxfoundation.org/mailman/listinfo/linux-kernel-mentees