Added correct versioning of this patch! Please ignore my previous post and sorry
for being trigger happy!

This is version 4 of the driver for Bosch Sensortec's accelerometers BMA150
and SMB380.

I didn't really get an ack on my suggestions in the previous version, but I
hope that this version covers the comments and suits your needs.

Here is the changelog:
* community review: added bma023 client id.
* community review: added irq handling for any-motion and high/low G
  interrupts.
* Added platfrom data struct for chip-configuration parameters.
* Removed the sysfs interfaces. These parameters are set through platform data instead.
* Removed pm_runtime, not needed if no sysfs interfaces.
* Populated default interrupt configurations as recommended by Bosch Sensortec.

--
Best regards,
 Eric

http://www.unixphere.com


Eric Andersson (1):
  input: add driver for Bosch Sensortec's BMA150 accelerometer

 drivers/input/misc/Kconfig  |   11 +
 drivers/input/misc/Makefile |    1 +
 drivers/input/misc/bma150.c |  598 +++++++++++++++++++++++++++++++++++++++++++
 include/linux/bma150.h      |   62 +++++
 4 files changed, 672 insertions(+), 0 deletions(-)
 create mode 100644 drivers/input/misc/bma150.c
 create mode 100644 include/linux/bma150.h

-- 
1.7.3.4