[PATCH 3/3] staging: sm750fb: Remove empty software I2C acknowledgement helper

From
Ali Köse <hidden>
Date
2026-11-14 10:02:27
Also in
linux-staging, lkml
Reply to
Ali Köse, 2026-11-14
sw_i2c_ack() contains only a return statement, so calling it has
no effect. Remove the empty helper and the ack parameter from
sw_i2c_read_byte(), along with the parameter documentation.

Update the only caller to use the parameterless helper. The GPIO
operations and existing I2C bus behavior remain unchanged.

Signed-off-by: Ali Köse <redacted>
---
 drivers/staging/sm750fb/ddk750_swi2c.c | 19 ++-----------------
 1 file changed, 2 insertions(+), 17 deletions(-)
diff --git a/drivers/staging/sm750fb/ddk750_swi2c.c b/drivers/staging/sm750fb/ddk750_swi2c.c
index e63f3b00ec4c..54ce355e535f 100644
--- a/drivers/staging/sm750fb/ddk750_swi2c.c
+++ b/drivers/staging/sm750fb/ddk750_swi2c.c
@@ -201,14 +201,6 @@ static unsigned char sw_i2c_read_sda(void)
 		return 0;
 }
 
-/*
- *  This function sends ACK signal
- */
-static void sw_i2c_ack(void)
-{
-	return;  /* Single byte read is ok without it. */
-}
-
 /*
  *  This function sends the start command to the slave device
  */
@@ -300,14 +292,10 @@ static long sw_i2c_write_byte(unsigned char data)
 /*
  *  This function reads one byte from the slave device
  *
- *  Parameters:
- *      ack    - Flag to indicate either to send the acknowledge
- *            message to the slave device or not
- *
  *  Return Value:
  *      One byte data read from the Slave device
  */
-static unsigned char sw_i2c_read_byte(unsigned char ack)
+static unsigned char sw_i2c_read_byte(void)
 {
 	int i;
 	unsigned char data = 0;
@@ -326,9 +314,6 @@ static unsigned char sw_i2c_read_byte(unsigned char ack)
 		data |= (sw_i2c_read_sda() << i);
 	}
 
-	if (ack)
-		sw_i2c_ack();
-
 	/* Set the SCL Low and SDA High */
 	sw_i2c_scl(0);
 	sw_i2c_sda(1);
@@ -458,7 +443,7 @@ unsigned char sm750_sw_i2c_read_reg(unsigned char addr, unsigned char reg)
 	/* Get the bus again and get the data from the device read address */
 	sw_i2c_start();
 	sw_i2c_write_byte(addr + 1);
-	data = sw_i2c_read_byte(1);
+	data = sw_i2c_read_byte();
 
 	/* Stop swI2C and release the bus */
 	sw_i2c_stop();
-- 
2.53.0
Thread (4 messages) 4 messages, 1 author, last reply 2d ago
Keyboard shortcuts
hback out one level
jnext message in thread / next series-diff position
kprevious message in thread / previous series-diff position
ldrill in
Escclose help / fold thread tree
?toggle this help