Re: [PATCH v2 1/2] dt-bindings: backlight: Add MPS MP3309C

On Fri, 15 Sep 2023 16:05:15 +0200, Flavio Suligoi wrote:

The Monolithic Power (MPS) MP3309C is a WLED step-up converter, featuring a
programmable switching frequency to optimize efficiency.
The brightness can be controlled either by I2C commands (called "analog"
mode) or by a PWM input signal (PWM mode).
This driver supports both modes.

For device driver details, please refer to:
- drivers/video/backlight/mp3309c_bl.c

The datasheet is available at:
- https://www.monolithicpower.com/en/mp3309c.html

Signed-off-by: Flavio Suligoi <f.suligoi@asem.it>
---

v2:
 - remove useless properties (dimming-mode, pinctrl-names, pinctrl-0,
   switch-on-delay-ms, switch-off-delay-ms, reset-gpios, reset-on-delay-ms,
   reset-on-length-ms)
 - add common.yaml#
 - remove already included properties (default-brightness, max-brightness)
 - substitute three boolean properties, used for the overvoltage-protection
   values, with a single enum property
 - remove some conditional definitions
 - remove the 2nd example
v1:
 - first version

 .../bindings/leds/backlight/mps,mp3309c.yaml  | 73 +++++++++++++++++++
 1 file changed, 73 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/leds/backlight/mps,mp3309c.yaml

My bot found errors running 'make DT_CHECKER_FLAGS=-m dt_binding_check'
on your patch (DT_CHECKER_FLAGS is new in v5.13):

yamllint warnings/errors:

dtschema/dtc warnings/errors:
Documentation/devicetree/bindings/leds/backlight/mps,mp3309c.example.dtb: /example-0/i2c/backlight@17: failed to match any schema with compatible: ['mps,mp3309c-backlight']

doc reference errors (make refcheckdocs):

See https://patchwork.ozlabs.org/project/devicetree-bindings/patch/20230915140516.1294925-1-f.suligoi@asem.it

The base for the series is generally the latest rc1. A different dependency
should be noted in *this* patch.

If you already ran 'make dt_binding_check' and didn't see the above
error(s), then make sure 'yamllint' is installed and dt-schema is up to
date:

pip3 install dtschema --upgrade

Please check and re-submit after running the above command yourself. Note
that DT_SCHEMA_FILES can be set to your schema file to speed up checking
your schema. However, it must be unset to test all examples with your schema.