Hi Tomi,
-----Original Message-----
From: Tomi Valkeinen [mailto:<redacted>]
Sent: Thursday, December 04, 2014 4:10 PM
To: Xiubo Li-B47053; Arnd Bergmann
Cc: <redacted>; <redacted>; linux-
kernel@vger.kernel.org; shawn.guo@linaro.org; alexander.stein@systec-
electronic.com
Subject: Re: [PATCHv2 0/4] LS1021A: Add dcfb framebuffer driver support.
Hi Xiubo,
On 04/12/14 03:56, Li.Xiubo@freescale.com wrote:
quoted
Hi Arnd,
Thanks for you advice.
Because this is very emergency for customers and have delayed for monthes,
and the
quoted
DRM/KMS will have a little long time to be supported. So I'd like to add
this first
quoted
and will add DRM/KMS version later.
I would also suggest to just write a drm driver for this. I don't see
anything special in this driver that would be better supported via
fbdev. With drm you'll get a more modern framework, and you will still
have the same /dev/fbX device to use for legacy userspace software.
What do you mean with "delayed for months"? The first version of this
series (that I can find) was posted less than two weeks ago.
Sorry for confusing, it was delayed for other reasons internal.
I am not familiar about the DRM, and I'd like to know if the DRM driver will be
support, should I also develop the libdrm too ? Or just coding in kernel level ?
Is there any Document about how to have /dev/fbX device to use ?
If possible, I'd like this could be accept for this time. And I will add the DRM
Version later(for developing and testing will take a long time).
Thanks very much,
BRs
Xiubo
Tomi