Diego A. Fons :

Hi,

First of all i'm not sure if it is the correct list for posting this 
mail, if it's not, please tell me wich list is the correct one.

I'm working on an embedded device (a Ronetix pm9261 board with an 
AT91SAM9261 cpu), i could build the linux kernel version 2.6.19.7 with 
framebuffer support and it works fine. The problem is when i run any 
command that uses net services, i.e. when i run sftp the sreen moves and 
it kept like this, the offset (0,0) is in position (100,0) (it's just an 
example, i don't know thw correct values) and i'm not able to correct 
it. It occurs every time i run a net comand. The display i'm usin is a 
LCD and the driver is sidsab.c.

Strange behavior is not it ;-)

I have seen this before and it was due to a bad timing setup of the
dm9000 chip select.

-	at91_sys_write(AT91_SMC_CYCLE(2), AT91_SMC_NWECYCLE_(0) | AT91_SMC_NRDCYCLE_(16));
+	at91_sys_write(AT91_SMC_CYCLE(2), AT91_SMC_NWECYCLE_(16) | AT91_SMC_NRDCYCLE_(16));

Is you have the first configuration, try with the second and it should
fix your problem.

Hope that it helps. Tell us if it works.

Regards,
-- 
Nicolas Ferre



-------------------------------------------------------------------------
This SF.net email is sponsored by DB2 Express
Download DB2 Express C - the FREE version of DB2 express and take
control of your XML. No limits. Just data. Click to get it now.
http://sourceforge.net/powerbar/db2/