Re: [PATCH v2 5/8] memory: tegra210: Support interconnect framework

From
Krzysztof Kozlowski <krzk@kernel.org>
Date
2025-09-04 08:17:07
Also in
linux-pm, linux-tegra, lkml
Reply to
Aaron Kling via B4 Relay, 2025-09-03
On Wed, Sep 03, 2025 at 02:50:11PM -0500, Aaron Kling wrote:
This makes mc and emc interconnect providers and allows for dynamic
memory clock scaling.

Signed-off-by: Aaron Kling <redacted>
---
 drivers/memory/tegra/Kconfig             |   1 +
 drivers/memory/tegra/tegra210-emc-core.c | 274 ++++++++++++++++++++++++++++++-
 drivers/memory/tegra/tegra210-emc.h      |  23 +++
 drivers/memory/tegra/tegra210.c          |  81 +++++++++
 4 files changed, 377 insertions(+), 2 deletions(-)
Patch #3 was memory, patch #4 was soc, patch #5 is memory, so that
mixup pattern continues.

Please address the earlier feedback.
quoted hunk ↗ jump to hunk
diff --git a/drivers/memory/tegra/Kconfig b/drivers/memory/tegra/Kconfig
index fc5a277918267ee8240f9fb9efeb80275db4790b..2d0be29afe2b9ebf9a0630ef7fb6fb43ff359499 100644
--- a/drivers/memory/tegra/Kconfig
+++ b/drivers/memory/tegra/Kconfig
@@ -55,6 +55,7 @@ config TEGRA210_EMC
 	tristate "NVIDIA Tegra210 External Memory Controller driver"
 	depends on ARCH_TEGRA_210_SOC || COMPILE_TEST
 	select TEGRA210_EMC_TABLE
+	select PM_OPP
 	help
 	  This driver is for the External Memory Controller (EMC) found on
 	  Tegra210 chips. The EMC controls the external DRAM on the board.
diff --git a/drivers/memory/tegra/tegra210-emc-core.c b/drivers/memory/tegra/tegra210-emc-core.c
index e96ca4157d48182574310f8caf72687bed7cc16a..f12e60b47fa87d629505cde57310d2bb68fc87f3 100644
--- a/drivers/memory/tegra/tegra210-emc-core.c
+++ b/drivers/memory/tegra/tegra210-emc-core.c
@@ -13,6 +13,7 @@
 #include <linux/module.h>
 #include <linux/of_reserved_mem.h>
 #include <linux/platform_device.h>
+#include <linux/pm_opp.h>
 #include <linux/slab.h>
 #include <linux/thermal.h>
 #include <soc/tegra/fuse.h>
@@ -1569,6 +1570,79 @@ static int tegra210_emc_set_rate(struct device *dev,
 	return 0;
 }
 
...
quoted hunk ↗ jump to hunk
@@ -1758,6 +1832,193 @@ static void tegra210_emc_debugfs_init(struct tegra210_emc *emc)
 			    &tegra210_emc_debug_temperature_fops);
 }
 
+static inline struct tegra210_emc *
+to_tegra210_emc_provider(struct icc_provider *provider)
+{
+	return container_of(provider, struct tegra210_emc, icc_provider);
+}
+
+static struct icc_node_data *
+emc_of_icc_xlate_extended(const struct of_phandle_args *spec, void *data)
+{
+	struct icc_provider *provider = data;
+	struct icc_node_data *ndata;
+	struct icc_node *node;
+
+	/* External Memory is the only possible ICC route */
+	list_for_each_entry(node, &provider->nodes, node_list) {
+		if (node->id != TEGRA_ICC_EMEM)
+			continue;
+
+		ndata = kzalloc(sizeof(*ndata), GFP_KERNEL);
+		if (!ndata)
+			return ERR_PTR(-ENOMEM);
+
+		/*
+		 * SRC and DST nodes should have matching TAG in order to have
+		 * it set by default for a requested path.
+		 */
+		ndata->tag = TEGRA_MC_ICC_TAG_ISO;
+		ndata->node = node;
+
+		return ndata;
+	}
+
+	return ERR_PTR(-EPROBE_DEFER);
+}
+
+static int emc_icc_set(struct icc_node *src, struct icc_node *dst)
+{
+	struct tegra210_emc *emc = to_tegra210_emc_provider(dst->provider);
+	unsigned long long peak_bw = icc_units_to_bps(dst->peak_bw);
+	unsigned long long avg_bw = icc_units_to_bps(dst->avg_bw);
+	unsigned long long rate = max(avg_bw, peak_bw);
+	const unsigned int ddr = 2;
Just use defines in top part for this.
quoted hunk ↗ jump to hunk
+	int err;
+
+	/*
+	 * Tegra210 memory layout can be 1 channel at 64-bit or 2 channels
+	 * at 32-bit each. Either way, the total bus width will always be
+	 * 64-bit.
+	 */
+	const unsigned int dram_data_bus_width_bytes = 64 / 8;
Same here.
quoted hunk ↗ jump to hunk
+
+	/*
+	 * Tegra210 EMC runs on a clock rate of SDRAM bus. This means that
+	 * EMC clock rate is twice smaller than the peak data rate because
+	 * data is sampled on both EMC clock edges.
+	 */
+	do_div(rate, ddr * dram_data_bus_width_bytes);
+	rate = min_t(u64, rate, U32_MAX);
+
+	err = emc_set_min_rate(emc, rate, EMC_RATE_ICC);
+	if (err)
+		return err;
+
+	return 0;
+}
+
+static int tegra_emc_icc_get_init_bw(struct icc_node *node, u32 *avg, u32 *peak)
+{
+	*avg = 0;
+	*peak = 0;
+
+	return 0;
+}
+
+static int tegra_emc_interconnect_init(struct tegra210_emc *emc)
+{
+	const struct tegra_mc_soc *soc = emc->mc->soc;
+	struct icc_node *node;
+	int err;
+
+	emc->icc_provider.dev = emc->dev;
+	emc->icc_provider.set = emc_icc_set;
+	emc->icc_provider.data = &emc->icc_provider;
+	emc->icc_provider.aggregate = soc->icc_ops->aggregate;
+	emc->icc_provider.xlate_extended = emc_of_icc_xlate_extended;
+	emc->icc_provider.get_bw = tegra_emc_icc_get_init_bw;
+
+	icc_provider_init(&emc->icc_provider);
+
+	/* create External Memory Controller node */
+	node = icc_node_create(TEGRA_ICC_EMC);
+	if (IS_ERR(node)) {
+		err = PTR_ERR(node);
+		goto err_msg;
+	}
+
+	node->name = "External Memory Controller";
+	icc_node_add(node, &emc->icc_provider);
+
+	/* link External Memory Controller to External Memory (DRAM) */
+	err = icc_link_create(node, TEGRA_ICC_EMEM);
+	if (err)
+		goto remove_nodes;
+
+	/* create External Memory node */
+	node = icc_node_create(TEGRA_ICC_EMEM);
+	if (IS_ERR(node)) {
+		err = PTR_ERR(node);
+		goto remove_nodes;
+	}
+
+	node->name = "External Memory (DRAM)";
+	icc_node_add(node, &emc->icc_provider);
+
+	err = icc_provider_register(&emc->icc_provider);
+	if (err)
+		goto remove_nodes;
+
+	return 0;
+
+remove_nodes:
+	icc_nodes_remove(&emc->icc_provider);
+err_msg:
+	dev_err(emc->dev, "failed to initialize ICC: %d\n", err);
+
+	return err;
+}
+
+static int tegra_emc_opp_table_init(struct tegra210_emc *emc)
+{
+	u32 hw_version = BIT(tegra_sku_info.soc_speedo_id);
+	struct dev_pm_opp *opp;
+	unsigned long rate;
+	int opp_token, err, max_opps, i;
+
+	err = dev_pm_opp_set_supported_hw(emc->dev, &hw_version, 1);
+	if (err < 0) {
+		dev_err(emc->dev, "failed to set OPP supported HW: %d\n", err);
+		return err;
+	}
+	opp_token = err;
+
+	err = dev_pm_opp_of_add_table(emc->dev);
+	if (err) {
+		if (err == -ENODEV)
+			dev_err(emc->dev, "OPP table not found, please update your device tree\n");
So this looks like the actual ABI break.

Best regards,
Krzysztof
Thread (21 messages) 21 messages, 4 authors, last reply 2025-09-06
Keyboard shortcuts
hback out one level
jnext message in thread / next series-diff position
kprevious message in thread / previous series-diff position
ldrill in
Escclose help / fold thread tree
?toggle this help