On 20/08/2022 11:29, Dario Binacchi wrote:

Add pin configurations for using CAN controller on stm32f469-disco
board. They are located on the Arduino compatible connector CN5 (CAN1)
and on the extension connector CN12 (CAN2).

Signed-off-by: Dario Binacchi <redacted>
Signed-off-by: Dario Binacchi <dario.binacchi@amarulasolutions.com>

Do not ignore review. This is not correct. You are mixing copyright with
SoC...

+			can2_pins_b: can2-1 {
+				pins1 {
+					pinmux = <STM32_PINMUX('B', 13, AF9)>; /* CAN2_TX */
+				};
+				pins2 {
+					pinmux = <STM32_PINMUX('B', 12, AF9)>; /* CAN2_RX */
+					bias-pull-up;
+				};
+			};
+

Don't ignore review.

That's second one, so that's a no.. :(

Best regards,
Krzysztof