Re: [PATCH v2 0/6] Configurable VLAN mode for NCSI driver

From
Jiaqing Zhao <hidden>
Date
2022-06-11 03:25:15
Also in
lkml, netdev, openbmc
Reply to
Jakub Kicinski, 2022-06-10
On 2022-06-11 04:09, Jakub Kicinski wrote:
On Sat, 11 Jun 2022 00:59:34 +0800 Jiaqing Zhao wrote:
quoted
Currently kernel NCSI driver only supports the "VLAN + non-VLAN" mode
(Mode #2), but this mode is an optional mode [1] defined in NCSI spec
and some NCSI devices like Intel E810 Network Adapter [2] does not
support that mode. This patchset adds a new "ncsi,vlan-mode" device
tree property for configuring the VLAN mode of NCSI device.

[1] Table 58 - VLAN Enable Modes
    https://www.dmtf.org/sites/default/files/standards/documents/DSP0222_1.0.0.pdf
[2] 12.6.5.4.3 VLAN
    https://cdrdv2.intel.com/v1/dl/getContent/613875
Please don't post the same patches more than once a day. You posted the
same patches 3 times within 15 minutes with no major difference :/
Got it, sorry for misusing the mailing list. 
Why is "ncsi,vlan-mode" set via the device tree? Looks like something
that can be configured at runtime. 
Actually this cannot be configured at runtime, the NCSI spec defines no
command or register to determine which mode is supported by the device.
If kernel want to enable VLAN on the NCSI device, either "Filtered tagged
+ Untagged" (current default) or "Any tagged + untagged" mode should be
enabled, but unfortunately both of these two modes are documented to be
optionally supported in the spec. And in real cases, there are devices
that only supports one of them, or neither of them. So I added the device
tree property to configure which mode to use.
Thread (17 messages) 17 messages, 3 authors, last reply 2022-06-14
Keyboard shortcuts
hback out one level
jnext message in thread / next series-diff position
kprevious message in thread / previous series-diff position
ldrill in
Escclose help / fold thread tree
?toggle this help