Hi Adam, Tim,

[...]

quoted

quoted

quoted

Nicolas and Adam,

For the H1 patches in this series: I've been able to test the IMX8MM
H1 JPEG encode using GStreamer 1.18.5:
$ gst-inspect-1.0 | grep -e "v4l2.*enc"
video4linux2:  v4l2jpegenc: V4L2 JPEG Encoder
$ gst-launch-1.0 videotestsrc ! jpegenc ! rtpjpegpay ! udpsink

                                  ^ v4l2jpegenc

This is just a transcript error ?

Nicolas,

No! Thanks for catching my mistake. I was testing with software encode... ooops!

'gst-launch-1.0 videotestsrc ! v4l2jpegenc ! fakesink' actually hangs
the board so likely a power-domain issue there?

The v4l2-compliance tests fail on the h1 decoder with a hang, but I
think we're writing to registers which are not documented in the Mini
TRM.  The Mini TRM doesn't explicitly show the JPEG encoding as a
feature, but some of the registers state JPEG, but because some of the
registers written for the H1 are not documented in the TRM.  If those
registers are restricted or not in this SoC, I am concerned that it
might be related.  I'll try to run some more tests this weekend to
check on the status of the power-domain stuff.

To verify if the HW support JPEG encoding you can read SWREG63 bit 25. This is
in the TRM, just not labelled properly. To mimic the decoding side, would be "HW
synthesis config register X" with the bit labelled SW_ENC_JPEG_PROF (but
PROF/profile is on or off). If your board hang while reading this, you likely
didn't get the power bit right.

IMX8 has an undocumented control block thing that we have been fighting with in
imx8q,  perhaps that's your issue. Few driver was proposed, we are still pending
on NXP solution to be submitted (they asked us to wait, still waiting =)).

quoted

quoted

quoted

host=192.168.1.146 port=5000
viewed on client@192.168.1.146 via:
$ gst-launch-1.0 udpsrc port=5000 ! application/x-rtp,payload=96 !
rtpjpegdepay ! jpegdec ! autovideosink

For the G1/G2 patches in the series I don't see any Gstreamer
'v4l2.*dec' elements. Perhaps I need a newer version of Gstreamer.

Most likely yes, I suggest building gstreamer/ branch "main", GStreamer has now
a single repository. We are very close to 1.20, which will include stable API
support of H264, MPEG2 and VP8 decoding.

Ok, let me see if I can navigate through the build process and I'll
get back to you.

Thanks,

Tim

quoted

quoted

I have CSI capture and DSI display currently working on
imx8mm-venice-gw73xx-0x that I can play with. The CSI sensor only
supports RAW8/RAW10 (and gstreamer currently only supports RAW8) and I
can't efficiently convert to something the JPEG encoder likes without
bayer2rgbneon (a libneon version).

I see from the IMX8MMRM that the 2D GPU supports scaling etc with a
wide range of data formats but I'm not sure how to tap into this as
that hardware is managed by the vivante driver. On the IMX6QDL there
is a separate IPU block that Philipp Zabel wrote a nice mem2mem
csc/scaler driver for but I don't see any equivalent currently for
IMX8MM.

Best regards,

Tim