Hi Prabhakar,

On Thu, Oct 28, 2021 at 10:59 AM Lad, Prabhakar
[off-list ref] wrote:

On Thu, Oct 28, 2021 at 8:56 AM Geert Uytterhoeven [off-list ref] wrote:

quoted

On Wed, Oct 27, 2021 at 3:45 PM Lad Prabhakar
[off-list ref] wrote:

quoted

Add support to get/set drive-strength and output-impedance-ohms
for the supported pins.

While at it also renamed the below macros to match the HW manual,
PIN_CFG_IOLH_SD0 -> PIN_CFG_IO_VMC_SD0
PIN_CFG_IOLH_SD1 -> PIN_CFG_IO_VMC_SD1
PIN_CFG_IOLH_QSPI -> PIN_CFG_IO_VMC_QSPI
PIN_CFG_IOLH_ETH0 -> PIN_CFG_IO_VMC_ETH0
PIN_CFG_IOLH_ETH1 -> PIN_CFG_IO_VMC_ETH1

Signed-off-by: Lad Prabhakar <prabhakar.mahadev-lad.rj@bp.renesas.com>

quoted

The rest looks good to me!

Thanks, I'll post a v2 just with patches 3 and 4 only. Hope that is OK with you.

That's fine for me.  I can take 1/4 and 2/4 of this series, if LinusW
and Rob give their Acked-by.

Gr{oetje,eeting}s,

                        Geert

--
Geert Uytterhoeven -- There's lots of Linux beyond ia32 -- geert@linux-m68k.org

In personal conversations with technical people, I call myself a hacker. But
when I'm talking to journalists I just say "programmer" or something like that.
                                -- Linus Torvalds