[net-next PATCH 08/13] dt-bindings: net: dsa: qca8k: Add MAC swap and clock phase properties
From: Ansuel Smith <ansuelsmth@gmail.com>
Date: 2021-10-06 22:36:53
Also in:
lkml, netdev
Subsystem:
networking drivers, networking [dsa], open firmware and flattened device tree bindings, the rest · Maintainers:
Andrew Lunn, "David S. Miller", Eric Dumazet, Jakub Kicinski, Paolo Abeni, Andrew Lunn, Vladimir Oltean, Rob Herring, Krzysztof Kozlowski, Conor Dooley, Linus Torvalds
Add names and decriptions of additional PORT0_PAD_CTRL properties. Document new binding qca,mac6_exchange that exchange the mac0 port with mac6. qca,sgmii-(rx|tx)clk-falling-edge are for setting the respective clock phase to failling edge. Signed-off-by: Ansuel Smith <ansuelsmth@gmail.com> Signed-off-by: Matthew Hagan <redacted> --- Documentation/devicetree/bindings/net/dsa/qca8k.txt | 3 +++ 1 file changed, 3 insertions(+)
diff --git a/Documentation/devicetree/bindings/net/dsa/qca8k.txt b/Documentation/devicetree/bindings/net/dsa/qca8k.txt
index 1f6b7d2f609e..780d1e60c425 100644
--- a/Documentation/devicetree/bindings/net/dsa/qca8k.txt
+++ b/Documentation/devicetree/bindings/net/dsa/qca8k.txt@@ -13,6 +13,9 @@ Required properties: Optional properties: - reset-gpios: GPIO to be used to reset the whole device +- qca,mac6-exchange: Internally swap MAC0 and MAC6. +- qca,sgmii-rxclk-falling-edge: Set the receive clock phase to falling edge. +- qca,sgmii-txclk-falling-edge: Set the transmit clock phase to falling edge. - qca,rgmii0-1-8v: Set the internal regulator to supply 1.8v for MAC0 port - qca,rgmii56-1-8v: Set the internal regulator to supply 1.8v for MAC5/6 port
--
2.32.0