On Tue, 11 May 2021 12:44:23 +0200
Hans de Goede [off-list ref] wrote:

Hi,

On 5/11/21 11:54 AM, Stephan Gerhold wrote:

quoted

KX023-1025 [1] is another accelerometer from Kionix that has lots
of additional functionality compared to KXCJK-1013. It combines the
motion interrupt functionality from KXCJK with the tap detection
from KXTF9, plus a lot more other functionality.

This patch set does not add support for any of the extra functionality,
but makes basic functionality work with the existing kxcjk-1013 driver.

At first, the register map for the KX023-1025 seems quite different
from the other accelerometers supported by the kxcjk-1013.
However, it turns out that at least most of the register bits
still mean the same for KX023-1025.

This patch set refactors the kxcjk-1013 driver a little bit
to get the register addresses from a chip-specific struct.
The register bits can be re-used for all the different chips.

The KX023-1025 is used in several smartphones from Huawei.
I tested these changes on a Huawei Ascend G7, someone else reported
they also work fine on the Huawei Honor 5X (codename "kiwi").

[1]: https://kionixfs.azureedge.net/en/datasheet/KX023-1025%20Specifications%20Rev%2012.0.pdf

Stephan Gerhold (3):
  dt-bindings: iio: kionix,kxcjk1013: Document kionix,kx023-1025
  iio: accel: kxcjk-1013: Refactor configuration registers into struct
  iio: accel: kxcjk-1013: Add support for KX023-1025  

Thanks, the entire series looks good to me:

Reviewed-by: Hans de Goede <redacted>

Other than those things 0-day found which would be good to tidy up for a v2
looks good to me.

Thanks,

Jonathan

for the series.

Regards,

Hans