Thread (13 messages) 13 messages, 5 authors, 2020-10-05

[PATCH v2 1/4] dt-bindings: net: Add bindings for AX88796C SPI Ethernet Adapter

flat view
STALE2205d SUPERSEDED

From: Łukasz Stelmach <l.stelmach@samsung.com>
Date: 2020-10-02 19:22:25
Also in: linux-arm-kernel, linux-samsung-soc, lkml, netdev
Subsystem: networking drivers, open firmware and flattened device tree bindings, the rest · Maintainers: Andrew Lunn, "David S. Miller", Eric Dumazet, Jakub Kicinski, Paolo Abeni, Rob Herring, Krzysztof Kozlowski, Conor Dooley, Linus Torvalds

Revision v2 of 17 in this series.

Revisions (17)
  1. v2 current
  2. v3 [diff vs current]
  3. v4 [diff vs current]
  4. v5 [diff vs current]
  5. v6 [diff vs current]
  6. v7 [diff vs current]
  7. v8 [diff vs current]
  8. v9 [diff vs current]
  9. v10 [diff vs current]
  10. v11 [diff vs current]
  11. v11 [diff vs current]
  12. v12 [diff vs current]
  13. v13 [diff vs current]
  14. v14 [diff vs current]
  15. v15 [diff vs current]
  16. v16 [diff vs current]
  17. v17 [diff vs current]
Add bindings for AX88796C SPI Ethernet Adapter.

Signed-off-by: Łukasz Stelmach <l.stelmach@samsung.com>
---
 .../bindings/net/asix,ax88796c-spi.yaml       | 76 +++++++++++++++++++
 .../devicetree/bindings/vendor-prefixes.yaml  |  2 +
 2 files changed, 78 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/net/asix,ax88796c-spi.yaml
diff --git a/Documentation/devicetree/bindings/net/asix,ax88796c-spi.yaml b/Documentation/devicetree/bindings/net/asix,ax88796c-spi.yaml
new file mode 100644
index 000000000000..50a488d59dbf
--- /dev/null
+++ b/Documentation/devicetree/bindings/net/asix,ax88796c-spi.yaml
@@ -0,0 +1,76 @@
+# SPDX-License-Identifier: GPL-2.0-only OR BSD-2-Clause
+%YAML 1.2
+---
+$id: http://devicetree.org/schemas/net/asix,ax88796c-spi.yaml#
+$schema: http://devicetree.org/meta-schemas/core.yaml#
+
+title: ASIX AX88796C SPI Ethernet Adapter
+
+allOf:
+  - $ref: ethernet-controller.yaml#
+
+description: |
+  ASIX AX88796C is an Ethernet controller with a built in PHY. This
+  describes SPI mode of the chip.
+
+  The node for this driver must be a child node of a SPI controller, hence
+  all mandatory properties described in ../spi/spi-bus.txt must be specified.
+
+maintainers:
+  - Łukasz Stelmach <l.stelmach@samsung.com>
+
+properties:
+  compatible:
+    const: asix,ax99796c-spi
+
+  reg:
+    description:
+      SPI device address.
+    maxItems: 1
+
+  spi-max-frequency:
+    maximum: 40000000
+
+  interrupts:
+    description:
+     GPIO interrupt to which the chip is connected.
+    maxItems: 1
+
+  interrupt-parrent:
+    description:
+      A phandle of an interrupt controller.
+    maxItems: 1
+
+  reset-gpios:
+    description:
+      A GPIO line handling reset of the chip. As the line is active low,
+      it should be marked GPIO_ACTIVE_LOW.
+    maxItems: 1
+
+  local-mac-address: true
+
+  mac-address: true
+
+required:
+  - compatible
+  - reg
+  - spi-max-frequency
+  - interrupts
+  - interrupt-parrent
+  - reset-gpios
+
+examples:
+  # Artik5 eval board
+  - |
+    ax88796c@0 {
+        compatible = "asix,ax88796c";
+        local-mac-address = [00 00 00 00 00 00]; /* Filled in by a bootloader */
+        interrupt-parent = <&gpx2>;
+        interrupts = <0 IRQ_TYPE_LEVEL_LOW>;
+        spi-max-frequency = <40000000>;
+        reg = <0x0>;
+        reset-gpios = <&gpe0 2 GPIO_ACTIVE_LOW>;
+        controller-data {
+            samsung,spi-feedback-delay = <2>;
+        };
+    };
diff --git a/Documentation/devicetree/bindings/vendor-prefixes.yaml b/Documentation/devicetree/bindings/vendor-prefixes.yaml
index 2baee2c817c1..5ce5c4a43735 100644
--- a/Documentation/devicetree/bindings/vendor-prefixes.yaml
+++ b/Documentation/devicetree/bindings/vendor-prefixes.yaml
@@ -117,6 +117,8 @@ patternProperties:
     description: Asahi Kasei Corp.
   "^asc,.*":
     description: All Sensors Corporation
+  "^asix,.*":
+    description: ASIX Electronics Corporation
   "^aspeed,.*":
     description: ASPEED Technology Inc.
   "^asus,.*":
-- 
2.26.2
Keyboard shortcuts
hback out one level
jnext message in thread
kprevious message in thread
ldrill in
Escclose help / fold thread tree
?toggle this help