---
 .../devicetree/bindings/media/i2c/ov8865.txt  | 51 +++++++++++++++++++
 1 file changed, 51 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/media/i2c/ov8865.txt

diff --git a/Documentation/devicetree/bindings/media/i2c/ov8865.txt b/Documentation/devicetree/bindings/media/i2c/ov8865.txt
new file mode 100644
index 000000000000..ac5a662288de
--- /dev/null
+++ b/Documentation/devicetree/bindings/media/i2c/ov8865.txt

@@ -0,0 +1,51 @@
+* Omnivision OV8865 MIPI CSI-2
+
+Required Properties:
+- compatible: should be "ovti,ov8865"
+- clocks: reference to the xclk input clock.
+- clock-names: should be "xclk".
+- DOVDD-supply: Digital I/O voltage supply, 2.8 volts
+- AVDD-supply: Analog voltage supply, 2.8 volts
+- AFVDD-supply: Analog voltage supply, 2.8 volts
+- DVDD-supply: Digital core voltage supply, 1.2 volts
+- reset-gpios: reference to the GPIO connected to the reset pin.
+	       This is an active low signal to the OV8865.
+- powerdown-gpios: reference to the GPIO connected to the powerdown pin.
+		   This is an active low signal to the OV8865.
+- rotation: as defined in
+	    Documentation/devicetree/bindings/media/video-interfaces.txt,
+	    valid values are 0 (sensor mounted upright) and 180 (sensor
+	    mounted upside down).
+- remote-endpoint: a phandle to the bus receiver's endpoint node.
+- clock-lanes: should be set to <0> (clock lane on hardware lane 0).
+- data-lanes: should be set to <4> (four CSI-2 lanes supported).
+
+The device node must contain one 'port' child node for its digital output video
+port, in accordance with the video interface bindings defined in
+Documentation/devicetree/bindings/media/video-interfaces.txt.