On Tue, Mar 10, 2020 at 08:44:38PM +0300, Dmitry Osipenko wrote:
10.03.2020 18:19, Thierry Reding пишет:
quoted
From: Joseph Lo <redacted>
The EMC clock needs to carefully coordinate with the EMC controller
programming to make sure external memory can be properly clocked. Do so
by hooking up the EMC clock with an EMC provider that will specify which
rates are supported by the EMC and provide a callback to use for setting
the clock rate at the EMC.
Based on work by Peter De Schrijver [off-list ref].
Signed-off-by: Joseph Lo <redacted>
Signed-off-by: Thierry Reding <redacted>
---
Changes in v5:
- major rework and cleanup
...
quoted
+static u8 tegra210_clk_emc_get_parent(struct clk_hw *hw)
+{
+ struct tegra210_clk_emc *emc = to_tegra210_clk_emc(hw);
+ u32 value;
+ u8 src;
+
+ value = readl_relaxed(emc->regs + CLK_SOURCE_EMC);
+ src = (value >> CLK_SOURCE_EMC_2X_CLK_SRC_SHIFT) &
+ CLK_SOURCE_EMC_2X_CLK_SRC_MASK;
What about to use a generic FIELD_GET/PREP()?
Done.
quoted
+static int tegra210_clk_emc_set_rate(struct clk_hw *hw, unsigned long rate,
+ unsigned long parent_rate)
+{
+ struct tegra210_clk_emc *emc = to_tegra210_clk_emc(hw);
+ struct tegra210_clk_emc_provider *provider = emc->provider;
+ struct tegra210_clk_emc_config *config;
+ struct device *dev = provider->dev;
+ struct clk_hw *old, *new, *parent;
+ u8 old_idx, new_idx, index;
+ struct clk *clk;
+ unsigned int i;
+ int err;
+
+ if (!provider || !provider->configs || provider->num_configs == 0)
+ return -EINVAL;
Why all these checks are needed? I don't think it ever could fail,
couldn't it?
This could fail if no EMC provider is attached, which happens, for
example, when the EMC driver is not loaded.
quoted
+static int emc_table_lookup(struct tegra_emc *emc, unsigned long rate)
+{
+ int i;
unsigned int
Same for all other occurrences in the code.
This was fixed automatically after I fixed the rebase issues.
Thierry