Re: [PATCH 06/22] arm64: dts: qcom: pm8150: Add Base DTS file
From: Stephen Boyd <sboyd@kernel.org>
Date: 2019-08-14 17:03:14
Also in:
linux-arm-msm, lkml
Quoting Vinod Koul (2019-08-14 05:49:56)
quoted hunk ↗ jump to hunk
Add base DTS file for pm8150 along with GPIOs Signed-off-by: Vinod Koul <vkoul@kernel.org> --- arch/arm64/boot/dts/qcom/pm8150.dtsi | 41 ++++++++++++++++++++++++++++ 1 file changed, 41 insertions(+) create mode 100644 arch/arm64/boot/dts/qcom/pm8150.dtsidiff --git a/arch/arm64/boot/dts/qcom/pm8150.dtsi b/arch/arm64/boot/dts/qcom/pm8150.dtsi new file mode 100644 index 000000000000..b533e254a203 --- /dev/null +++ b/arch/arm64/boot/dts/qcom/pm8150.dtsi@@ -0,0 +1,41 @@ +// SPDX-License-Identifier: BSD-3-Clause +// Copyright (c) 2017-2019, The Linux Foundation. All rights reserved. +// Copyright (c) 2019, Linaro Limited + +#include <dt-bindings/interrupt-controller/irq.h> +#include <dt-bindings/spmi/spmi.h> + +&spmi_bus { + pm8150_0: pm8150@0 {
I think node name should be 'pmic'
+ compatible = "qcom,spmi-pmic";
This should also have the model number? "qcom,pm8150"?
+ reg = <0x0 SPMI_USID>;
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ pm8150_gpios: gpio@c000 {
+ compatible = "qcom,pm8150-gpio";
+ reg = <0xc000>;
+ gpio-controller;
+ #gpio-cells = <2>;
+ interrupts = <0 0xc0 0 IRQ_TYPE_NONE>,
+ <0 0xc1 0 IRQ_TYPE_NONE>,
+ <0 0xc2 0 IRQ_TYPE_NONE>,
+ <0 0xc3 0 IRQ_TYPE_NONE>,
+ <0 0xc4 0 IRQ_TYPE_NONE>,
+ <0 0xc5 0 IRQ_TYPE_NONE>,
+ <0 0xc6 0 IRQ_TYPE_NONE>,
+ <0 0xc7 0 IRQ_TYPE_NONE>,
+ <0 0xc8 0 IRQ_TYPE_NONE>,
+ <0 0xc9 0 IRQ_TYPE_NONE>,
+ <0 0xca 0 IRQ_TYPE_NONE>,
+ <0 0xcb 0 IRQ_TYPE_NONE>;
+ };
+ };
+
+ qcom,pm8150@1 {Same comment, pmic@1.
+ compatible ="qcom,spmi-pmic"; + reg = <0x1 SPMI_USID>; + #address-cells = <1>; + #size-cells = <0>; + }; +};