[PATCH v5 12/14] arm64: dts: qcom: pmi8994: add interrupt controller properties
From: Brian Masney <hidden>
Date: 2019-01-17 00:33:35
Also in:
linux-arm-msm, linux-gpio, lkml
Subsystem:
arm/qualcomm mailing list, arm/qualcomm support, the rest · Maintainers:
Bjorn Andersson, Konrad Dybcio, Linus Torvalds
Add interrupt controller properties now that spmi-gpio is a proper hierarchical IRQ chip. The interrupts property is no longer needed so remove it. This change was not tested on any hardware but the same change was tested on qcom-pm8941.dtsi using a LG Nexus 5 (hammerhead) phone with no issues. Signed-off-by: Brian Masney <redacted> Reviewed-by: Stephen Boyd <sboyd@kernel.org> Reviewed-by: Bjorn Andersson <redacted> --- Changes since v4: - None Patch introduced in v4. arch/arm64/boot/dts/qcom/pmi8994.dtsi | 12 ++---------- 1 file changed, 2 insertions(+), 10 deletions(-)
diff --git a/arch/arm64/boot/dts/qcom/pmi8994.dtsi b/arch/arm64/boot/dts/qcom/pmi8994.dtsi
index dae1cdc23f54..3aee10e3f921 100644
--- a/arch/arm64/boot/dts/qcom/pmi8994.dtsi
+++ b/arch/arm64/boot/dts/qcom/pmi8994.dtsi@@ -15,16 +15,8 @@ reg = <0xc000>; gpio-controller; #gpio-cells = <2>; - interrupts = <2 0xc0 0 IRQ_TYPE_NONE>, - <2 0xc1 0 IRQ_TYPE_NONE>, - <2 0xc2 0 IRQ_TYPE_NONE>, - <2 0xc3 0 IRQ_TYPE_NONE>, - <2 0xc4 0 IRQ_TYPE_NONE>, - <2 0xc5 0 IRQ_TYPE_NONE>, - <2 0xc6 0 IRQ_TYPE_NONE>, - <2 0xc7 0 IRQ_TYPE_NONE>, - <2 0xc8 0 IRQ_TYPE_NONE>, - <2 0xc9 0 IRQ_TYPE_NONE>; + interrupt-controller; + #interrupt-cells = <2>; }; };
--
2.17.2