[PATCH 18/40] mmc: tegra: Perform pad calibration after voltage switch
From: Aapo Vienamo <hidden>
Date: 2018-08-01 16:33:41
Also in:
linux-mmc, linux-tegra, lkml
Subsystem:
multimedia card (mmc), secure digital (sd) and sdio subsystem, secure digital host controller interface (sdhci) driver, the rest · Maintainers:
Ulf Hansson, Adrian Hunter, Linus Torvalds
Run the automatic pad calibration after voltage switching if tegra_host->pad_calib_required is set. Signed-off-by: Aapo Vienamo <redacted> --- drivers/mmc/host/sdhci-tegra.c | 5 +++++ 1 file changed, 5 insertions(+)
diff --git a/drivers/mmc/host/sdhci-tegra.c b/drivers/mmc/host/sdhci-tegra.c
index 681987e..2b87f3a4 100644
--- a/drivers/mmc/host/sdhci-tegra.c
+++ b/drivers/mmc/host/sdhci-tegra.c@@ -571,6 +571,8 @@ static int sdhci_tegra_start_signal_voltage_switch(struct mmc_host *mmc, struct mmc_ios *ios) { struct sdhci_host *host = mmc_priv(mmc); + struct sdhci_pltfm_host *pltfm_host = sdhci_priv(host); + struct sdhci_tegra *tegra_host = sdhci_pltfm_priv(pltfm_host); int ret = 0; if (ios->signal_voltage == MMC_SIGNAL_VOLTAGE_330) {
@@ -585,6 +587,9 @@ static int sdhci_tegra_start_signal_voltage_switch(struct mmc_host *mmc, ret = tegra_sdhci_set_padctrl(host, ios->signal_voltage); } + if (tegra_host->pad_calib_required) + tegra_sdhci_pad_autocalib(host); + return ret; }
--
2.7.4