On Tue, Jun 21, 2016 at 2:07 PM, Alexandre Belloni
[off-list ref] wrote:

On 21/06/2016 at 15:49:04 -0500, Rob Herring wrote :

quoted

So wouldn't you want to set one mode while running and the lower power
mode while suspended? I'm trying to understand the frequency of changing
this. If it is always one setting for a board, then yes it belongs in
DT. If it is a user decision, then it probably shouldn't be in DT.

Seeing as these are reused, I've probably already had this discussion...

I would agree with Rob here. It may be better to provide a sysfs
interface to configure that particular behavior.

I don't see any value in doing that, could you give me a realistic
example of a scenario in which a user would want to spend some of
uptime with RTC oscillator fault detection/glitch filtering disabled
and then enable it?

This is usually ok because the use case is:
 - the RTC is not configured, time has never been set
 - time is set for the first time
 - the user can set the oscillator mode/detection/...

Unfortunately exposing that feature using sysfs gives you a leaky
abstraction and your userspace instead of using a generic RTC starts
using DS1341 RTC. So to accommodate for that a user would have to:

a) Write + integrate a userspace tool to set the mode (which IMHO is
decided upon once and doesn't change)
b) If a board design is new and there's a chance of moving this chip
to a different I2C bus, the code above would have to account for that
and not hardcore sysfs path
c) If board's BSP is intended to be used in multiple generations of a
product, not all of which would use DS1341, it would be necessary to
accommodate for that by either more code in the tool or an additional
BSP build configuration variant

 - on subsequent reboots, the mode is kept alongside the time and date

This assumes that your bootloader leaves those mode bits alone.

I would advise against trying to set a mode automatically in the driver
because you may have unexpected power cuts and it may then let the RTC
consume more power than what you really want.

I fell like I am not understanding you correctly.  Why would moving
configuration decision logic into userspace improve the situation in
case of unexpected power loss?

Andrey

-- 
You received this message because you are subscribed to "rtc-linux".
Membership options at http://groups.google.com/group/rtc-linux .
Please read http://groups.google.com/group/rtc-linux/web/checklist
before submitting a driver.
--- 
You received this message because you are subscribed to the Google Groups "rtc-linux" group.
To unsubscribe from this group and stop receiving emails from it, send an email to rtc-linux+unsubscribe-/JYPxA39Uh5TLH3MbocFF+G/Ez6ZCGd0@public.gmane.org
For more options, visit https://groups.google.com/d/optout.