Thanks Nico,

On 24/03/16 16:51, Nicolas Dechesne wrote:

On Wed, Mar 23, 2016 at 8:48 PM, Srinivas Kandagatla
[off-list ref] wrote:

quoted

+                       led@1 {
+                               label = "dragonboard-600c:green:user1";
+                               gpios = <&tlmm_pinmux 3 GPIO_ACTIVE_HIGH>;
+                               linux,default-trigger = "heartbeat";
+                               default-state = "off";
+                       };
+
+                       led@2 {
+                               label = "dragonboard-600c:green:user2";
+                               gpios = <&tlmm_pinmux 7 GPIO_ACTIVE_HIGH>;
+                               linux,default-trigger = "mmc0";
+                               default-state = "off";
+                       };
+
+                       led@3 {
+                               label = "dragonboard-600c:green:user3";
+                               gpios = <&tlmm_pinmux 10 GPIO_ACTIVE_HIGH>;
+                               linux,default-trigger = "mmc1";
+                               default-state = "off";
+                       };
+
+                       led@4 {
+                               label = "apq8016-sbc:green:user4";

typo ^^

Yep, Will fix this.

quoted

+                               gpios = <&tlmm_pinmux 11 GPIO_ACTIVE_HIGH>;
+                               linux,default-trigger = "none";
+                               default-state = "off";
+                       };

also, if i read the 96boards specs correctly, the LED are labeled
3-2-1-0 , if you look at the board with the LEDs on the bottom. With
this DT config, you end up with 0-1-2-3 instead.

also, they should be labeled 0 to 3, not 1 to 4.

I agree Will fix it. The structure was copied from the 8016.

Its strange that DB410c LEDS labels on the board are from 1 to 4 rather 
than 0 to 3, on the other hand DB600c does not have any labels as such.

For Now I can change DB600c to start with 0 rather than 1.