On Thu, Jan 21, 2016 at 11:26:11AM +0100, Lothar Waßmann wrote:

quoted

On Thu, Jan 21, 2016 at 08:05:24AM +0100, Lothar Waßmann wrote:

quoted

quoted

On Wed, Jan 20, 2016 at 01:29:51PM +0100, Lothar Waßmann wrote:

quoted

quoted

quoted

quoted

This pin is used as IRQ pin for the LTC3589 PMIC on the Ka-Ro
electronics TX48 module. Make the IRQ optional in the driver and use a
polling routine instead if no IRQ is specified in DT.
Otherwise the driver will continuously generate interrupts and make
the system unusable.

quoted

quoted

quoted

How will the driver generate interrupts if there is no interrupt
physically present in the system?

quoted

quoted

It's using timer interrupts to poll the LTC3589 state.

quoted

I know that is what your patch does, my question is why you say in your
commit log that "Otherwise the driver will continuously generate
interrupts and make the system unusable".

Because the interrupt is level triggered and the polarity of the
EXTINT pin is inverted, the interrupt will be constantly active when
the IRQ pin of the LTC3589 is inactive.

So, to repeat my original question, how will that generate interrupts if
there is no interrupt physically present in the system?