Hi Andrey,

On Mon, Jul 20, 2015 at 11:35:43PM +0300, Andrey Danin wrote:

Initialization code is based on NVEC driver.

There is a HW bug in AP20 that was also mentioned in kernel sources
for Toshiba AC100.

Signed-off-by: Andrey Danin <redacted>

Still doesn't work for me and I think I understand why. Do you run your
I2C controller in slave mode only? That might work, but using it in
master/slave mode simultanously won't work yet as I see it:

* After every transfer (as master), clocks get disabled. I assume the IP
  core won't be able to detect its own address then.

* There is this code in tegra_i2c_init():

	if (!i2c_dev->is_dvc) {
		u32 sl_cfg = i2c_readl(i2c_dev, I2C_SL_CNFG);
		sl_cfg |= I2C_SL_CNFG_NACK | I2C_SL_CNFG_NEWSL;
		i2c_writel(i2c_dev, sl_cfg, I2C_SL_CNFG);
		i2c_writel(i2c_dev, 0xfc, I2C_SL_ADDR1);
		i2c_writel(i2c_dev, 0x00, I2C_SL_ADDR2);

	}

  It probably messes up the slave initialization in tegra_reg_slave().
  At least I see that the slave address gets overwritten when I peek
  the register after boot.

Does that make sense to you?

Thanks,

   Wolfram