[PATCH 0/2] net: davinci_mdio: reuse for keystone2 arch
From: Grygorii Strashko <grygorii.strashko@ti.com>
Date: 2014-07-09 12:24:30
Also in:
lkml, netdev
The similar MDIO HW blocks is used by keystone 2 SoCs as in Davinci SoCs: - one in Gigabit Ethernet (GbE) Switch Subsystem See http://www.ti.com/lit/ug/sprugv9d/sprugv9d.pdf - one in 10 Gigabit Ethernet Subsystem See http://www.ti.com/lit/ug/spruhj5/spruhj5.pdf Hence, reuse Davinci MDIO driver for Keystone 2 and enable TI networking for Keystone 2 devices. Also, as part of this series, enable PHY's creation from DT, because Keystone 2 supports DT boot mode only. Grygorii Strashko (2): net: davinci_mdio: reuse for keystone2 arch net: davinci_mdio: allow to create phys from dt .../devicetree/bindings/net/davinci-mdio.txt | 8 ++++---- drivers/net/ethernet/ti/Kconfig | 4 ++-- drivers/net/ethernet/ti/davinci_mdio.c | 18 ++++++++++++++++-- 3 files changed, 22 insertions(+), 8 deletions(-) -- 1.7.9.5