Re: [PATCH v4 3/4] ARM: dts: bcm2837-rpi-3-b: Add bcm43438 serial slave

Marcel Holtmann [off-list ref] writes:

Hi Loic,

quoted

Add BCM43438 (bluetooth) as a slave device of uart0 (pl011/ttyAMA0).
This allows to automatically insert the bcm43438 to the bluetooth
subsystem instead of relying on userspace helpers (hciattach).

Overwrite chosen/stdout-path to use 8250 aux uart as console.

Signed-off-by: Loic Poulain <redacted>
---
v2: dt-bindings as separate patch
    rebase on upcoming pi3 dts changes
v3: changes in bcm serdev drivers:
    name refactoring and additional comments
    Add generic host_set_baudrate method
    Use agnostic device_property_read
v4: changes in doc and dts:
    Add additional params to broadcom bt dt-bindings
    Set the max baudrate to 2000000 instead of 921600
    use chosen/stdout-path instead of console=
    remove useless earlyprintk
    same changes in bcm283x.dtsi

arch/arm/boot/dts/bcm2837-rpi-3-b.dts | 10 ++++++++++
1 file changed, 10 insertions(+)

do you mind resending the 2 pending patches with Rob’s ack on it. And ensure that this goes with DT tree since I can currently not take it since net-next has not pulled in the pending DT patches.

Normally we wouldn't need a resend and I'd just apply the acks when
applying the DT patches, but I don't see them in my mail.

(Also, note that since we're already at rc6 I might not be able to apply
DT patches to -next until rc1 rolls around)