[RFC 6/7] ARM: dts: OMAP3-N900: Add bluetooth
From: Sebastian Reichel <sre@kernel.org>
Date: 2016-08-13 03:15:27
Also in:
linux-devicetree, linux-omap, linux-serial, lkml
Subsystem:
the rest · Maintainer:
Linus Torvalds
Add bcm2048 node and its system clock to the N900 device tree file. Apart from that a reference to the new clock has been added to wl1251 (which uses it, too). Signed-off-by: Sebastian Reichel <sre@kernel.org> --- arch/arm/boot/dts/omap3-n900.dts | 22 +++++++++++++++++++++- 1 file changed, 21 insertions(+), 1 deletion(-)
diff --git a/arch/arm/boot/dts/omap3-n900.dts b/arch/arm/boot/dts/omap3-n900.dts
index 1d7b1d0d471a..1dba4a64d8fd 100644
--- a/arch/arm/boot/dts/omap3-n900.dts
+++ b/arch/arm/boot/dts/omap3-n900.dts@@ -155,6 +155,13 @@ compatible = "nokia,n900-ir"; pwms = <&pwm9 0 26316 0>; /* 38000 Hz */ }; + + /* controlled (enabled/disabled) directly by bcm2048 and wl1251 */ + vctcxo: vctcxo { + compatible = "fixed-clock"; + #clock-cells = <0>; + clock-frequency = <38400000>; + }; }; &omap3_pmx_core {
@@ -162,8 +169,10 @@ uart2_pins: pinmux_uart2_pins { pinctrl-single,pins = < - OMAP3_CORE1_IOPAD(0x217a, PIN_INPUT | MUX_MODE0) /* uart2_rx */ + OMAP3_CORE1_IOPAD(0x2174, PIN_INPUT | MUX_MODE0) /* uart2_cts */ + OMAP3_CORE1_IOPAD(0x2176, PIN_OUTPUT | MUX_MODE0) /* uart2_rts */ OMAP3_CORE1_IOPAD(0x2178, PIN_OUTPUT | MUX_MODE0) /* uart2_tx */ + OMAP3_CORE1_IOPAD(0x217a, PIN_INPUT | MUX_MODE0) /* uart2_rx */ >; };
@@ -917,6 +926,8 @@ interrupt-parent = <&gpio2>; interrupts = <10 IRQ_TYPE_NONE>; /* gpio line 42 */ + + clocks = <&vctcxo>; }; };
@@ -937,6 +948,15 @@ interrupts-extended = <&intc 73 &omap3_pmx_core OMAP3_UART2_RX>; pinctrl-names = "default"; pinctrl-0 = <&uart2_pins>; + + bcm2048: bluetooth { + compatible = "nokia,brcm,bcm2048"; + reset-gpios = <&gpio3 27 GPIO_ACTIVE_HIGH>; /* 91 */ + host-wakeup-gpios = <&gpio4 5 GPIO_ACTIVE_HIGH>; /* 101 */ + bluetooth-wakeup-gpios = <&gpio2 5 GPIO_ACTIVE_HIGH>; /* 37 */ + clocks = <&vctcxo>; + clock-names = "sysclk"; + }; }; &uart3 {
--
2.8.1