Re: [Bluez-devel] pand + socket filtering on zaurus

Hi Matthias,

OK, I got the ROM 3.10 and installed the latest bluez-2.4.18...ipk
sucessfully. Then, I do NOT enter a BT CF Card, which I assume would wrok
perfectly, but I connect a BT Chip using a serial cable instead. 
# modprobe l2cap
# modprobe hci_uart
# hciattach /dev/ttyS0 any 115200 flow
fails ---->  "Can't set device: Protocol not support"
no matter whether I am using the hciattach kindly sended 
by Steve or the one that I cross compiled myself, the answer is always the
same. 

this problem occurs when hciattach will set the device mode (H4 or BCSP)
and I suspect your hci_uart is very old. In the beginning there was no
switch needed, but it also only supported H4. Maybe it is enough to
erase the ioctl(HCIUARTSETPROTO), but using a too old BlueZ stack is not
a good idea.

Regards

Marcel




-------------------------------------------------------
This SF.Net email is sponsored by the new InstallShield X.

From Windows to Linux, servers to mobile, InstallShield X is the one

installation-authoring solution that does it all. Learn more and
evaluate today! http://www.installshield.com/Dev2Dev/0504
_______________________________________________
Bluez-devel mailing list
Bluez-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/bluez-devel