From: William Wu <redacted>

According to the LFPS Tx Low Power/LFPS Rx Detect Threshold [1],
the device under test(DUT) must not respond if LFPS below the
minimum LFPS Rx Detect Threshold 100mV. Test fail on Rockchip
platforms, because the default LFPS detect threshold is set to
65mV.

The USBDP PHY LFPS detect threshold voltage could be set to
30mV ~ 140mV, and since there could be 10-20% PVT variation,
we set LFPS detect threshold voltage to 110mV.

[1] https://compliance.usb.org/resources/LFPS_Rx_Tx_Low_Power_Compliance_Update_Rev5.pdf

Signed-off-by: William Wu <redacted>
[Taken over from rockchip's kernel tree; the registers are not described
in the TRM]
Reviewed-by: Neil Armstrong <neil.armstrong@linaro.org>
Signed-off-by: Sebastian Reichel <redacted>
---
 drivers/phy/rockchip/phy-rockchip-usbdp.c | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

diff --git a/drivers/phy/rockchip/phy-rockchip-usbdp.c b/drivers/phy/rockchip/phy-rockchip-usbdp.c
index 923279ed7d77..8202abab4274 100644
--- a/drivers/phy/rockchip/phy-rockchip-usbdp.c
+++ b/drivers/phy/rockchip/phy-rockchip-usbdp.c

@@ -413,7 +413,8 @@ static const struct reg_sequence rk_udphy_init_sequence[] = {
 	{0x0070, 0x7d}, {0x0074, 0x68},
 	{0x0af4, 0x1a}, {0x1af4, 0x1a},
 	{0x0440, 0x3f}, {0x10d4, 0x08},
-	{0x20d4, 0x08}, {0x0024, 0x6e}
+	{0x20d4, 0x08}, {0x0024, 0x6e},
+	{0x09c0, 0x0a}, {0x19c0, 0x0a}
 };
 
 static inline int rk_udphy_grfreg_write(struct regmap *base,

-- 
2.53.0