Re: [PATCH 3/3] ARM: dts: imx7-mba7: disable boot_cfg pins after boot
From: Frank Li <Frank.li@nxp.com>
Date: 2026-02-18 16:42:48
Also in:
imx, linux-devicetree, lkml
On Wed, Feb 18, 2026 at 02:54:14PM +0100, Alexander Feilke wrote:
The BOOT_CFG pins are located on the LCD bus on our starterkit. Disable them after boot to separate those signals.
Your comments is more clear. Is below commit massage better? ARM: dts: imx7-mba7: Deassert BOOT_EN to separate BOOT_CFG circuits after boot Deassert BOOT_EN after boot to separate BOOT_CFG circuits from LCD signals. Frank
quoted hunk ↗ jump to hunk
Signed-off-by: Alexander Feilke <redacted> --- arch/arm/boot/dts/nxp/imx/imx7-mba7.dtsi | 9 +++++++++ 1 file changed, 9 insertions(+)diff --git a/arch/arm/boot/dts/nxp/imx/imx7-mba7.dtsi b/arch/arm/boot/dts/nxp/imx/imx7-mba7.dtsi index 03f2f2cbdfbc..4192adb27223 100644 --- a/arch/arm/boot/dts/nxp/imx/imx7-mba7.dtsi +++ b/arch/arm/boot/dts/nxp/imx/imx7-mba7.dtsi@@ -287,6 +287,15 @@ &flexcan2 { status = "okay"; }; +&gpio4 { + /* Deassert BOOT_EN after boot to separate BOOT_CFG circuits from LCD signals */ + boot-en-hog { + gpio-hog; + gpios = <3 GPIO_ACTIVE_LOW>; + output-low; + }; +}; + &i2c1 { lm75: temperature-sensor@49 { compatible = "national,lm75a"; --2.43.0