On Fri, Sep 12, 2025 at 11:02:22AM +0100, Andre Przywara wrote:

On Fri, 12 Sep 2025 01:52:08 +0200
J. Neuschäfer via B4 Relay [off-list ref] wrote:

Hi,

quoted

This patchset adds an initial devicetree for the X96Q set-top box.
WiFi, Ethernet, and HDMI depend on drivers that are currently not
available in mainline Linux, and I didn't enable them in the devicetree.
The builtin infrared receiver produces IRQs when a nearby remote sends
events, but I have not checked whether the events are decoded correctly.

You can either do a simple "cat /dev/input/event<x>", then check whether
keypresses generate (unreadable) output, or you use the "evtest" tool to
decode some information:
https://cgit.freedesktop.org/evtest/

I get nothing out of /dev/input/event0 (the sunxi-ir device) or
/dev/lirc0, which is quite strange. After putting some printks into
drivers/media/rc/sunxi-cir.c, I do see the raw events, but they are
somehow not forwarded to the input device.

But I guess if you see interrupts consistent with remote keypresses, it's
a good enough indication it should work.

Cheers,
Andre