[PATCH v6 7/9] arm64: dts: imx95-15x15-evk: Use phys to replace xceiver-supply
From: Peng Fan <peng.fan@nxp.com>
Date: 2025-09-09 05:41:16
Also in:
imx, linux-can, linux-devicetree, linux-phy, lkml
Subsystem:
arm/freescale imx / mxc arm architecture, the rest · Maintainers:
Frank Li, Sascha Hauer, Linus Torvalds
The TJA1051T/3 used on i.MX95-15x15-EVK is actually high-speed CAN transceiver, not a regulator supply. So use phys to reflect the truth. Reviewed-by: Frank Li <Frank.Li@nxp.com> Signed-off-by: Peng Fan <peng.fan@nxp.com> --- arch/arm64/boot/dts/freescale/imx95-15x15-evk.dts | 13 ++++++------- 1 file changed, 6 insertions(+), 7 deletions(-)
diff --git a/arch/arm64/boot/dts/freescale/imx95-15x15-evk.dts b/arch/arm64/boot/dts/freescale/imx95-15x15-evk.dts
index 148243470dd4ab03afdae949c8316f31467d1377..a15f021498869918945405cc7f34ea7e27ae6aea 100644
--- a/arch/arm64/boot/dts/freescale/imx95-15x15-evk.dts
+++ b/arch/arm64/boot/dts/freescale/imx95-15x15-evk.dts@@ -106,12 +106,11 @@ reg_audio_switch1: regulator-audio-switch1 { gpio = <&pcal6524 0 GPIO_ACTIVE_LOW>; }; - reg_can2_stby: regulator-can2-stby { - compatible = "regulator-fixed"; - regulator-max-microvolt = <3300000>; - regulator-min-microvolt = <3300000>; - regulator-name = "can2-stby"; - gpio = <&pcal6524 14 GPIO_ACTIVE_LOW>; + flexcan2_phy: can-phy { + compatible = "nxp,tja1051"; + #phy-cells = <0>; + max-bitrate = <5000000>; + silent-gpios = <&pcal6524 14 GPIO_ACTIVE_HIGH>; }; reg_m2_pwr: regulator-m2-pwr {
@@ -317,7 +316,7 @@ &enetc_port1 { &flexcan2 { pinctrl-0 = <&pinctrl_flexcan2>; pinctrl-names = "default"; - xceiver-supply = <®_can2_stby>; + phys = <&flexcan2_phy>; status = "okay"; };
--
2.37.1