On Fri, Mar 01, 2024 at 04:35:02PM +0100, Romain Gantois wrote:
There is a reocurring issue with stmmac controllers where the MAC fails to
initialize its hardware if an RX clock signal isn't provided on the MAC/PHY
link.
This causes issues when PHY or PCS devices either go into suspend while
cutting the RX clock or do not bring the clock signal up early enough for
the MAC to initialize successfully.
Set the mac_requires_rxc flag in the stmmac phylink config so that PHY/PCS
drivers know to keep the RX clock up at all times.
Reported-by: Clark Wang <xiaoning.wang@nxp.com>
Link: https://lore.kernel.org/all/20230202081559.3553637-1-xiaoning.wang@nxp.com/ (local)
Reported-by: Clément Léger <redacted>
Link: https://lore.kernel.org/linux-arm-kernel/20230116103926.276869-4-clement.leger@bootlin.com/ (local)
Suggested-by: Russell King <linux@armlinux.org.uk>
This should be:
Co-developed-by: Russell King (Oracle) <redacted>
quoted hunk ↗ jump to hunk
Signed-off-by: Romain Gantois <romain.gantois@bootlin.com>
---
drivers/net/ethernet/stmicro/stmmac/stmmac_main.c | 7 +++++++
1 file changed, 7 insertions(+)
diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
index 79844dbe4258..2290f4808d7e 100644
--- a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
+++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
@@ -1218,6 +1218,9 @@ static int stmmac_phy_setup(struct stmmac_priv *priv)
priv->phylink_config.type = PHYLINK_NETDEV;
priv->phylink_config.mac_managed_pm = true;
+ /* Stmmac always requires an RX clock for hardware initialization */
+ priv->phylink_config.mac_requires_rxc = true;
+
mdio_bus_data = priv->plat->mdio_bus_data;
if (mdio_bus_data)
priv->phylink_config.ovr_an_inband =
@@ -3408,6 +3411,10 @@ static int stmmac_hw_setup(struct net_device *dev, bool ptp_register)
u32 chan;
int ret;
+ /* Make sure RX clock is enabled */
+ if (priv->hw->phylink_pcs)
+ phylink_pcs_pre_init(priv->phylink, priv->hw->phylink_pcs);
+
/* DMA initialization and SW reset */
ret = stmmac_init_dma_engine(priv);
if (ret < 0) {
--
2.43.2
--
RMK's Patch system: https://www.armlinux.org.uk/developer/patches/
FTTP is here! 80Mbps down 10Mbps up. Decent connectivity at last!
_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel