On Wed, 21 Feb 2024 14:04:22 +0100 Romain Gantois wrote:
There is a reocurring issue with stmmac controllers where the MAC fails to
initialize its hardware if an RX clock signal isn't provided on the MAC/PHY
link.
This causes issues when PHY or PCS devices either go into suspend while
cutting the RX clock or do not bring the clock signal up early enough for
the MAC to initialize successfully.
Set the mac_requires_rxc flag in the stmmac phylink config so that PHY/PCS
drivers know to keep the RX clock up at all times.
Reported-by: Clark Wang <xiaoning.wang@nxp.com>
Link: https://lore.kernel.org/all/20230202081559.3553637-1-xiaoning.wang@nxp.com/ (local)
Reported-by: Clément Léger <redacted>
Link: https://lore.kernel.org/linux-arm-kernel/20230116103926.276869-4-clement.leger@bootlin.com/ (local)
Suggested-by: Russell King <linux@armlinux.org.uk>
Signed-off-by: Romain Gantois <romain.gantois@bootlin.com>
breaks allmodconfig:
ERROR: modpost: "phylink_pcs_pre_init" [drivers/net/ethernet/stmicro/stmmac/stmmac.ko] undefined!
--
pw-bot: cr
_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel