On Wed, Feb 21, 2024 at 02:04:19PM +0100, Romain Gantois wrote:
Some MAC drivers (e.g. stmmac) require a continuous receive clock signal to
be generated by a PCS that is handled by a standalone PCS driver.
Such a PCS driver does not have access to a PHY device, thus cannot check
the PHY_F_RXC_ALWAYS_ON flag. They cannot check max_requires_rxc in the
phylink config either, since it is a private member. Therefore, a new flag
is needed to signal to the PCS that it should keep the RX clock signal up
at all times.
Suggested-by: Russell King <linux@armlinux.org.uk>
Signed-off-by: Romain Gantois <romain.gantois@bootlin.com>
...
quoted hunk ↗ jump to hunk
@@ -549,6 +557,34 @@ void pcs_an_restart(struct phylink_pcs *pcs);
*/
void pcs_link_up(struct phylink_pcs *pcs, unsigned int neg_mode,
phy_interface_t interface, int speed, int duplex);
+
+/**
+ * pcs_pre_init() - Configure PCS components necessary for MAC initialization
+ * @pcs: a pointer to a &struct phylink_pcs.
+ *
+ * This function can be called by MAC drivers through the
+ * phylink_pcs_pre_init() wrapper, before their hardware is initialized. It
+ * should not be called after the link is brought up, as reconfiguring the PCS
+ * at this point could break the link.
+ *
+ * Some MAC devices require specific hardware initialization to be performed by
+ * their associated PCS device before they can properly initialize their own
+ * hardware. An example of this is the initialization of stmmac controllers,
+ * which requires an active REF_CLK signal to be provided by the PHY/PCS.
+ *
+ * By calling phylink_pcs_pre_init(), MAC drivers can ensure that the PCS is
+ * setup in a way that allows for successful hardware initialization.
+ *
+ * The specific configuration performed by pcs_pre_init() is dependent on the
+ * model of PCS and the requirements of the MAC device attached to it. PCS
+ * driver authors should consider whether their target device is to be used in
+ * conjunction with a MAC device whose driver calls phylink_pcs_pre_init(). MAC
+ * driver authors should document their requirements for the PCS
+ * pre-initialization.
+ *
+ */
+int pcs_config(struct phylink_pcs *pcs);
Hi Romain,
Should this be pcs_pre_init instead of pcs_config?
quoted hunk ↗ jump to hunk
+
#endif
struct phylink *phylink_create(struct phylink_config *,
...
_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel