On Mon, Sep 27, 2021 at 9:51 PM Chin-Ting Kuo
[off-list ref] wrote:

Hi Rob,

quoted

-----Original Message-----
From: Rob Herring <robh@kernel.org>
Sent: Tuesday, September 28, 2021 2:59 AM
To: Chin-Ting Kuo <chin-ting_kuo@aspeedtech.com>
Subject: Re: [PATCH 10/10] dt-bindings: mmc: aspeed: Add a new compatible
string

On Wed, Sep 22, 2021 at 06:31:16PM +0800, Chin-Ting Kuo wrote:

quoted

Add "aspeed,ast2600-emmc" compatible string for the sake of
distinguishing between SD and eMMC device.

Why?

Is the h/w block different? We already have properties to handle some of the
eMMC specifics. Also, you can have a child node for the eMMC device if you
need that.

There are two SD/SDIO controllers in a AST2600 SoC.
One is for SD card and the other is for eMMC.
Although both of them are embedded in the same SoC, the design of delay cell and
the manufacture process are different. The delay phase is definitely different and, thus,
we need a flag, compatible, to distinguish the device, SD or eMMC.

Without "aspeed,ast2600-emmc" compatible, of course, eMMC device can work with original
sdhci driver and device tree setting. But, for ultra-speed or HS200 case, AST2600 SoC needs some
phase delay which (maximum) value is different between SD and eMMC device.

This is quite common as tweaking the timing is also need per board.
Look at what other bindings have done. A property is more appropriate
here.

Rob

_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel