Hi,

Am 26.08.21 um 21:03 schrieb Fabio Estevam:

Hi Marcel,

On Thu, Aug 19, 2021 at 11:04 AM Marcel Ziswiler [off-list ref] wrote:

quoted

From: Marcel Ziswiler <redacted>

Enable CONFIG_FB which is nowadays required for CONFIG_DRM_PANEL_LVDS,
CONFIG_DRM_PANEL_SIMPLE, CONFIG_DRM_PANEL_SEIKO_43WVF1G,
CONFIG_FB_MODE_HELPERS, CONFIG_BACKLIGHT_PWM, CONFIG_BACKLIGHT_GPIO,
CONFIG_FRAMEBUFFER_CONSOLE, CONFIG_LOGO, CONFIG_FONTS, CONFIG_FONT_8x8
and CONFIG_FONT_8x16.

Signed-off-by: Marcel Ziswiler <redacted>

Yes, I noticed that I had no LCD output on an imx6ull-evk board and
after selecting CONFIG_FB it works again.

this was caused by:

f611b1e7624c ("drm: Avoid circular dependencies for CONFIG_FB")

Best regards

For the entire series:

Reviewed-by: Fabio Estevam <festevam@gmail.com>

_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel

_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel