[PATCH v3 1/6] phy/rockchip: inno-hdmi: use correct vco_div_5 macro on rk3328
From: Jonas Karlman <jonas@kwiboo.se>
Date: 2020-10-10 22:51:58
Also in:
linux-rockchip, lkml
Subsystem:
arm/rockchip soc support, generic phy framework, the rest · Maintainers:
Heiko Stuebner, Vinod Koul, Linus Torvalds
inno_hdmi_phy_rk3328_clk_set_rate() is using the RK3228 macro
when configuring vco_div_5 on RK3328.
Fix this by using correct vco_div_5 macro for RK3328.
Fixes: 53706a116863 ("phy: add Rockchip Innosilicon hdmi phy")
Signed-off-by: Jonas Karlman <jonas@kwiboo.se>
---
drivers/phy/rockchip/phy-rockchip-inno-hdmi.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/drivers/phy/rockchip/phy-rockchip-inno-hdmi.c b/drivers/phy/rockchip/phy-rockchip-inno-hdmi.c
index 9ca20c947283..b0ac1d3ee390 100644
--- a/drivers/phy/rockchip/phy-rockchip-inno-hdmi.c
+++ b/drivers/phy/rockchip/phy-rockchip-inno-hdmi.c@@ -790,8 +790,8 @@ static int inno_hdmi_phy_rk3328_clk_set_rate(struct clk_hw *hw, RK3328_PRE_PLL_POWER_DOWN); /* Configure pre-pll */ - inno_update_bits(inno, 0xa0, RK3228_PCLK_VCO_DIV_5_MASK, - RK3228_PCLK_VCO_DIV_5(cfg->vco_div_5_en)); + inno_update_bits(inno, 0xa0, RK3328_PCLK_VCO_DIV_5_MASK, + RK3328_PCLK_VCO_DIV_5(cfg->vco_div_5_en)); inno_write(inno, 0xa1, RK3328_PRE_PLL_PRE_DIV(cfg->prediv)); val = RK3328_SPREAD_SPECTRUM_MOD_DISABLE;
--
2.17.1
_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel