Hi Nishanth,

On 02/10/20 12:43 am, Nishanth Menon wrote:

On 00:35-20201002, Faiz Abbas wrote:

quoted

The following patches add support for UHS modes for TI's j721e and j7200
boards.

Patches 1-3 add support for gpios to j7200-evm

Patches 4-6 add support for voltage regulators for required by the
SD card in both devices as well as enable UHS modes at 1.8V

Patches 5-6 add some required configs to the arm64 defconfig.

This series depends on driver patches adding tuning support here:
https://lore.kernel.org/linux-arm-kernel/20200923105206.7988-1-faiz_abbas@ti.com/ (local)

Faiz Abbas (8):
  arm64: dts: ti: k3-j7200-main: Add gpio nodes in main domain
  arm64: dts: ti: k3-j7200: Add gpio nodes in wakeup domain
  arm64: dts: ti: k3-j7200-common-proc-board: Disable unused gpio
    modules
  arm64: dts: ti: k3-j721e-main: Add output tap delay values
  arm64: dts: ti: k3-j721e-common-proc-board: Add support SD card UHS
    modes
  arm64: dts: ti: k3-j7200-common-proc-board: Add support SD card UHS
    modes

Split these up please!

Into SD card UHS and gpio series?

quoted

  arm64: defconfig: Enable OMAP I2C driver
  arm64: defconfig: Enable DAVINCI_GPIO driver

defconfig patches can be posted independent of dts patches, they go to
different branches.

I was trying to follow Arnd's advice here:
https://lore.kernel.org/linux-arm-kernel/CAK8P3a1JpCCCV-CVQj3+eMfWF+=4AuHPpv390Tyj2pKn63_ZVg@mail.gmail.com/ (local)

He says that defconfig patches can be sent at the same time as dts updates and maintainers can send those
as separate pull requests.

Thanks,
Faiz

_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel