[PATCH 1/5] phy: amlogic: phy-meson-gxl-usb2: keep ID pull-up even in Host mode
From: Neil Armstrong <hidden>
Date: 2020-09-09 16:53:47
Also in:
linux-amlogic, linux-usb, lkml
Subsystem:
arm/amlogic meson soc support, generic phy framework, the rest · Maintainers:
Neil Armstrong, Kevin Hilman, Vinod Koul, Linus Torvalds
In order to keep OTG ID detection even when in Host mode, the ID line of the PHY (if the current phy is an OTG one) pull-up should be kept enable in both modes. This fixes OTG switch on GXL, GXM & AXG platforms, otherwise once switched to Host, the ID detection doesn't work anymore to switch back to Device. Signed-off-by: Neil Armstrong <redacted> --- drivers/phy/amlogic/phy-meson-gxl-usb2.c | 3 ++- 1 file changed, 2 insertions(+), 1 deletion(-)
diff --git a/drivers/phy/amlogic/phy-meson-gxl-usb2.c b/drivers/phy/amlogic/phy-meson-gxl-usb2.c
index 43ec9bf24abf..6e862ea60d8f 100644
--- a/drivers/phy/amlogic/phy-meson-gxl-usb2.c
+++ b/drivers/phy/amlogic/phy-meson-gxl-usb2.c@@ -158,7 +158,8 @@ static int phy_meson_gxl_usb2_set_mode(struct phy *phy, U2P_R0_DM_PULLDOWN); regmap_update_bits(priv->regmap, U2P_R0, U2P_R0_DP_PULLDOWN, U2P_R0_DP_PULLDOWN); - regmap_update_bits(priv->regmap, U2P_R0, U2P_R0_ID_PULLUP, 0); + regmap_update_bits(priv->regmap, U2P_R0, U2P_R0_ID_PULLUP, + U2P_R0_ID_PULLUP); break; case PHY_MODE_USB_DEVICE:
--
2.22.0
_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel