hi All,

On Fri, 21 Aug 2020 at 10:13, Anand Moon [off-list ref] wrote:

Hi Kevin,

Thanks for your review comments.

On Fri, 21 Aug 2020 at 01:03, Kevin Hilman [off-list ref] wrote:

quoted

Anand Moon [off-list ref] writes:

quoted

Enable RTC PCF8563 node on Odroid-N2 SBC, In order to
support the RTC wakealarm feature for suspend and resume.
Also assign an alias to the pcf8563 to rtc0 and meson-vrtc to rtc1
timer device to prevent it being assigned to /dev/rtc0
which disto userspace tools assume is a clock device.

Cc: Neil Armstrong <redacted>
Cc: Kevin Hilman <khilman@baylibre.com>
Suggested-by: Christian Hewitt <redacted>
Signed-off-by: Anand Moon <redacted>
---
Changes V3
--Drop the INI GPIOAO.BIT7 pinctrl.

Why did you drop this GPIO?  Isn't this the GPIO that the RTC uses to
wakeup the system?  If so, this should be included as part of this
patch.

It probably still works because the bootloader configures this GPIO as
input, but the kernel should not rely on the booloader for that, so
please include as part of this patch.

Ok I will figure out the correct pinctrl need for this settings.
looking into the Odroid N2 schematics.

I am trying to map the RTC INT pinctrl, ie RTC INT GPIOAO.BIT7.

So from the schematics it is seen below.
RTC INT  GPIOAO_7 (AV46)   GPIOAO_7 (JTAG_A_TMS // TSIN_A_DIN0 //
TDMB_FS // TDMB_SLV_FS)

But the S922X datasheet this pin *AV46* shows to following settings,
AN16    DVSS    AV46      GPIOAO_7    BD19    BOOT_11

From the schematics it BOOT_11 is linked to
              BOOT_11 (NAND_CE0)      BD19

So can I conclude that BOOT_11 (nand_ce0_pins) pin linked to the RTC INT setting
Please can somebody help me with correct pinctrl settings.

Best Regards
-Anand Moon

_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel