Thread (27 messages) 27 messages, 5 authors, 2020-07-02

Re: [RFC PATCH v5 1/6] dt-bindings: exynos-bus: Add documentation for interconnect properties

From: Sylwester Nawrocki <s.nawrocki@samsung.com>
Date: 2020-06-01 08:19:49
Also in: dri-devel, linux-devicetree, linux-samsung-soc, lkml

Cc: Rob, devicetree ML

On 29.05.2020 18:31, Sylwester Nawrocki wrote:
quoted hunk ↗ jump to hunk
Add documentation for new optional properties in the exynos bus nodes:
samsung,interconnect-parent, #interconnect-cells.
These properties allow to specify the SoC interconnect structure which
then allows the interconnect consumer devices to request specific
bandwidth requirements.

Signed-off-by: Artur Świgoń <a.swigon@samsung.com>
Signed-off-by: Sylwester Nawrocki <s.nawrocki@samsung.com>
---
Changes for v5:
 - exynos,interconnect-parent-node renamed to samsung,interconnect-parent
---
 Documentation/devicetree/bindings/devfreq/exynos-bus.txt | 15 +++++++++++++--
 1 file changed, 13 insertions(+), 2 deletions(-)
diff --git a/Documentation/devicetree/bindings/devfreq/exynos-bus.txt b/Documentation/devicetree/bindings/devfreq/exynos-bus.txt
index e71f752..e0d2daa 100644
--- a/Documentation/devicetree/bindings/devfreq/exynos-bus.txt
+++ b/Documentation/devicetree/bindings/devfreq/exynos-bus.txt
@@ -51,6 +51,11 @@ Optional properties only for parent bus device:
 - exynos,saturation-ratio: the percentage value which is used to calibrate
 			the performance count against total cycle count.

+Optional properties for interconnect functionality (QoS frequency constraints):
+- samsung,interconnect-parent: phandle to the parent interconnect node; for
+  passive devices should point to same node as the exynos,parent-bus property.
+- #interconnect-cells: should be 0
+
 Detailed correlation between sub-blocks and power line according to Exynos SoC:
 - In case of Exynos3250, there are two power line as following:
 	VDD_MIF |--- DMC
@@ -185,8 +190,9 @@ Example1:
 	----------------------------------------------------------

 Example2 :
-	The bus of DMC (Dynamic Memory Controller) block in exynos3250.dtsi
-	is listed below:
+	The bus of DMC (Dynamic Memory Controller) block in exynos3250.dtsi is
+	listed below. An interconnect path "bus_lcd0 -- bus_leftbus -- bus_dmc"
+	is defined for demonstration purposes.

 	bus_dmc: bus_dmc {
 		compatible = "samsung,exynos-bus";
@@ -376,12 +382,15 @@ Example2 :
 	&bus_dmc {
 		devfreq-events = <&ppmu_dmc0_3>, <&ppmu_dmc1_3>;
 		vdd-supply = <&buck1_reg>;	/* VDD_MIF */
+		#interconnect-cells = <0>;
 		status = "okay";
 	};

 	&bus_leftbus {
 		devfreq-events = <&ppmu_leftbus_3>, <&ppmu_rightbus_3>;
 		vdd-supply = <&buck3_reg>;
+		samsung,interconnect-parent = <&bus_dmc>;
+		#interconnect-cells = <0>;
 		status = "okay";
 	};
@@ -392,6 +401,8 @@ Example2 :

 	&bus_lcd0 {
 		devfreq = <&bus_leftbus>;
+		samsung,interconnect-parent = <&bus_leftbus>;
+		#interconnect-cells = <0>;
 		status = "okay";
 	};

--
2.7.4
_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
Keyboard shortcuts
hback out one level
jnext message in thread
kprevious message in thread
ldrill in
Escclose help / fold thread tree
?toggle this help