Re: [PATCH] ARM: dts: omap3: Migrate AES from hwmods to sysc-omap2

On Tue, May 5, 2020 at 1:42 PM Tony Lindgren [off-list ref] wrote:

* Adam Ford [off-list ref] [200504 16:02]:

quoted

Various OMAP3 boards have two AES blocks, but only one is currently
available, because the hwmods are only configured for one.

This patch migrates the hwmods for the AES engine to sysc-omap2
which allows the second AES crypto engine to become available.

  omap-aes 480a6000.aes1: OMAP AES hw accel rev: 2.6
  omap-aes 480a6000.aes1: will run requests pump with realtime priority
  omap-aes 480c5000.aes2: OMAP AES hw accel rev: 2.6
  omap-aes 480c5000.aes2: will run requests pump with realtime priority

Great :) Looks like I'm getting the following though:

DTC     arch/arm/boot/dts/am3517-craneboard.dtb
arch/arm/boot/dts/omap3.dtsi:160.39-184.5: ERROR (phandle_references):
/ocp@68000000/target-module@480a6000:
Reference to non-existent node or label "aes1_ick"

Is this patch maybe missing a change for am3717 for the aes1_ick?

I am guessing it's the same issue that plagues the am3517 with a note
in the hwmods that stated noone seems to know which am3517's support
it and which don't.  The RNG was disabled on the 3517, so I am
guessing I'll do the same for AES.
I should have posted it as an RFC, because I don't have the proper IRQ
setup for the newly supported AES engine.  The interrupts that are
used for the original AES are listed as 'Resereved' in the AM3517 TRM.
I assume the second engine uses different interrupts.  I don't suppose
anyone know what it should be?

adam

Regards,

Tony

_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel