RE: [PATCH v6] arm64: dts: qcom: sc7180: Add WCN3990 WLAN module device node

Hi Evan,

I have sent out the v7 patch by marking a dependency on the below mentioned series
https://patchwork.kernel.org/project/linux-wireless/list/?series=261367 

The clocks are missing:
clocks = <&rpmhcc RPMH_RF_CLK2>;
clock-names = "cxo_ref_clk_pin";

These clocks are optional and were required for older firmware.
It's not needed now.

Thanks,
Rakesh Pillai

-----Original Message-----
From: Evan Green <redacted>
Sent: Wednesday, March 25, 2020 9:34 PM
To: pillair@codeaurora.org
Cc: open list:OPEN FIRMWARE AND FLATTENED DEVICE TREE BINDINGS
[off-list ref]; linux-arm Mailing List <linux-arm-
kernel@lists.infradead.org>; LKML [off-list ref]; linux-
arm-msm [off-list ref]
Subject: Re: [PATCH v6] arm64: dts: qcom: sc7180: Add WCN3990 WLAN
module device node

On Wed, Mar 25, 2020 at 4:05 AM [off-list ref] wrote:

quoted

Hi Evan,

I will send out a v7 for this patchset.
Since I have to configure the S2 SIDs, it is dependent on below ath10k

patchset.

quoted

https://patchwork.kernel.org/project/linux-wireless/list/?series=261367

Ah, right. Thanks for the info, I'll check out that series as well.
-Evan

_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel