Re: [PATCH] arm64: dts: clearfog-gt-8k: set gigabit PHY reset deassert delay
From: Baruch Siach <baruch@tkos.co.il>
Date: 2020-02-25 15:53:11
Also in:
linux-devicetree
Hi Russell, On Tue, Feb 25, 2020 at 11:45:12AM +0000, Russell King wrote:
If the mv88e6xxx DSA driver is built as a module, it causes the
ethernet driver to re-probe when it's loaded. This in turn causes
the gigabit PHY to be momentarily reset and reprogrammed. However,
we attempt to reprogram the PHY immediately after deasserting reset,
and the PHY ignores the writes.
This results in the PHY operating in the wrong mode, and the copper
link states down.
Set a reset deassert delay of 10ms for the gigabit PHY to avoid this.
Fixes: babc5544c293 ("arm64: dts: clearfog-gt-8k: 1G eth PHY reset signal")
Signed-off-by: Russell King <redacted>Acked-by: Baruch Siach <baruch@tkos.co.il> Thanks, baruch
quoted hunk ↗ jump to hunk
--- arch/arm64/boot/dts/marvell/armada-8040-clearfog-gt-8k.dts | 1 + 1 file changed, 1 insertion(+)diff --git a/arch/arm64/boot/dts/marvell/armada-8040-clearfog-gt-8k.dts b/arch/arm64/boot/dts/marvell/armada-8040-clearfog-gt-8k.dts index bd881497b872..dc531d136273 100644 --- a/arch/arm64/boot/dts/marvell/armada-8040-clearfog-gt-8k.dts +++ b/arch/arm64/boot/dts/marvell/armada-8040-clearfog-gt-8k.dts@@ -367,6 +367,7 @@ pinctrl-0 = <&cp0_copper_eth_phy_reset>; reset-gpios = <&cp0_gpio2 11 GPIO_ACTIVE_LOW>; reset-assert-us = <10000>; + reset-deassert-us = <10000>; }; switch0: switch0@4 {
--
http://baruch.siach.name/blog/ ~. .~ Tk Open Systems
=}------------------------------------------------ooO--U--Ooo------------{=
- baruch@tkos.co.il - tel: +972.2.679.5364, http://www.tkos.co.il -
_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel