[PATCH] arm64: dts: clearfog-gt-8k: set gigabit PHY reset deassert delay
From: Russell King <hidden>
Date: 2020-02-25 11:45:26
Also in:
linux-devicetree
Subsystem:
arm/marvell kirkwood and armada 370, 375, 38x, 39x, xp, 3700, 7k/8k, cn9130 soc support, the rest · Maintainers:
Andrew Lunn, Gregory Clement, Sebastian Hesselbarth, Linus Torvalds
If the mv88e6xxx DSA driver is built as a module, it causes the
ethernet driver to re-probe when it's loaded. This in turn causes
the gigabit PHY to be momentarily reset and reprogrammed. However,
we attempt to reprogram the PHY immediately after deasserting reset,
and the PHY ignores the writes.
This results in the PHY operating in the wrong mode, and the copper
link states down.
Set a reset deassert delay of 10ms for the gigabit PHY to avoid this.
Fixes: babc5544c293 ("arm64: dts: clearfog-gt-8k: 1G eth PHY reset signal")
Signed-off-by: Russell King <redacted>
---
arch/arm64/boot/dts/marvell/armada-8040-clearfog-gt-8k.dts | 1 +
1 file changed, 1 insertion(+)
diff --git a/arch/arm64/boot/dts/marvell/armada-8040-clearfog-gt-8k.dts b/arch/arm64/boot/dts/marvell/armada-8040-clearfog-gt-8k.dts
index bd881497b872..dc531d136273 100644
--- a/arch/arm64/boot/dts/marvell/armada-8040-clearfog-gt-8k.dts
+++ b/arch/arm64/boot/dts/marvell/armada-8040-clearfog-gt-8k.dts@@ -367,6 +367,7 @@ pinctrl-0 = <&cp0_copper_eth_phy_reset>; reset-gpios = <&cp0_gpio2 11 GPIO_ACTIVE_LOW>; reset-assert-us = <10000>; + reset-deassert-us = <10000>; }; switch0: switch0@4 {
--
2.20.1
_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel