Hi Scott,

On Wed, 2019-01-16 at 10:15 -0800, Scott Branden wrote:

On 2019-01-15 10:44 a.m., Florian Fainelli wrote:

quoted

Add support for resetting blocks through the Linux reset controller
subsystem when reset lines are provided through a SW_INIT-style reset
controller on Broadcom STB SoCs.

Signed-off-by: Florian Fainelli <f.fainelli@gmail.com>
---
  drivers/reset/Kconfig         |   7 ++
  drivers/reset/Makefile        |   1 +
  drivers/reset/reset-brcmstb.c | 130 ++++++++++++++++++++++++++++++++++
  3 files changed, 138 insertions(+)
  create mode 100644 drivers/reset/reset-brcmstb.c

diff --git a/drivers/reset/Kconfig b/drivers/reset/Kconfig
index 2e01bd833ffd..1ca03c57e049 100644
--- a/drivers/reset/Kconfig
+++ b/drivers/reset/Kconfig

@@ -40,6 +40,13 @@ config RESET_BERLIN
  	help
  	  This enables the reset controller driver for Marvell Berlin SoCs.
  
+config RESET_BRCMSTB
+	bool "Broadcom STB reset controller" if COMPILE_TEST

Could this even be:

depends on ARCH_BRCMSTB || COMPILE_TEST

I don't think this is necessary. Since the symbol is non-interactive if
COMPILE_TEST is disabled, it just vanishes when both are disabled.

quoted

+	default ARCH_BRCMSTB

And if it is actually needed, it defaults to the correct value.

regards
Philipp

_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel