The A64 has a MIPI-DSI block which is similar to A31
without mod clock.

So, add dsi node with A64 compatible, dphy node with
A31 compatible and finally connect dsi to tcon0 to
make proper DSI pipeline.

Signed-off-by: Jagan Teki <jagan@amarulasolutions.com>
---
 arch/arm64/boot/dts/allwinner/sun50i-a64.dtsi | 45 +++++++++++++++++++
 1 file changed, 45 insertions(+)

diff --git a/arch/arm64/boot/dts/allwinner/sun50i-a64.dtsi b/arch/arm64/boot/dts/allwinner/sun50i-a64.dtsi
index dd5740bc3fc9..dd5c7ad55149 100644
--- a/arch/arm64/boot/dts/allwinner/sun50i-a64.dtsi
+++ b/arch/arm64/boot/dts/allwinner/sun50i-a64.dtsi

@@ -344,6 +344,12 @@
 					#address-cells = <1>;
 					#size-cells = <0>;
 					reg = <1>;
+
+					tcon0_out_dsi: endpoint@1 {
+						reg = <1>;
+						remote-endpoint = <&dsi_in_tcon0>;
+						allwinner,tcon-channel = <1>;
+					};
 				};
 			};
 		};

@@ -910,6 +916,45 @@
 			status = "disabled";
 		};
 
+		dsi: dsi@1ca0000 {
+			compatible = "allwinner,sun50i-a64-mipi-dsi";
+			reg = <0x01ca0000 0x1000>;
+			interrupts = <GIC_SPI 89 IRQ_TYPE_LEVEL_HIGH>;
+			clocks = <&ccu CLK_BUS_MIPI_DSI>;
+			clock-names = "bus";
+			resets = <&ccu RST_BUS_MIPI_DSI>;
+			phys = <&dphy>;
+			phy-names = "dphy";
+			status = "disabled";
+
+			ports {
+				#address-cells = <1>;
+				#size-cells = <0>;
+
+				port@0 {
+					#address-cells = <1>;
+					#size-cells = <0>;
+					reg = <0>;
+
+					dsi_in_tcon0: endpoint {
+						remote-endpoint = <&tcon0_out_dsi>;
+					};