[PATCH v4 6/6] dt-bindings: media: rcar-vin: Clarify optional props
From: jacopo+renesas@jmondi.org (Jacopo Mondi)
Date: 2018-06-12 14:26:06
Also in:
linux-devicetree, linux-media, linux-renesas-soc
Subsystem:
media input infrastructure (v4l/dvb), open firmware and flattened device tree bindings, the rest · Maintainers:
Mauro Carvalho Chehab, Rob Herring, Krzysztof Kozlowski, Conor Dooley, Linus Torvalds
Add a note to the R-Car VIN interface bindings to clarify that all properties listed as generic properties in video-interfaces.txt can be included in port at 0 endpoint, but if not explicitly listed in the interface bindings documentation, they do not modify it behaviour. Signed-off-by: Jacopo Mondi <jacopo+renesas@jmondi.org> --- Documentation/devicetree/bindings/media/rcar_vin.txt | 6 ++++++ 1 file changed, 6 insertions(+)
diff --git a/Documentation/devicetree/bindings/media/rcar_vin.txt b/Documentation/devicetree/bindings/media/rcar_vin.txt
index 8130849..03544c7 100644
--- a/Documentation/devicetree/bindings/media/rcar_vin.txt
+++ b/Documentation/devicetree/bindings/media/rcar_vin.txt@@ -55,6 +55,12 @@ from local SoC CSI-2 receivers (port1) depending on SoC. instances that are connected to external pins should have port 0. - Optional properties for endpoint nodes of port at 0: + + All properties described in [1] and which apply to the selected + media bus type could be optionally listed here to better describe + the current hardware configuration, but only the following ones do + actually modify the VIN interface behaviour: + - hsync-active: see [1] for description. Default is active high. - vsync-active: see [1] for description. Default is active high. - data-enable-active: polarity of CLKENB signal, see [1] for
--
2.7.4